HP Chromebook 11 G3 Display Assembly Replacement

Geschrieben von: Rahul Goyal
  • Kommentare: 1
HP Chromebook 11 G3 Display Assembly Replacement

Schwierigkeitsgrad

Moderate

Schritte

10

Zeitaufwand

7 Minuten

Einleitung

Use this guide to remove the display assembly of the HP Chromebook 11 G3.

  1. kTLULoYvMWqxSApe
    kTLULoYvMWqxSApe
    3SOKsBJG3UuYRUqV

    • Flip the laptop upside down so that the lid lies flat on the table.

    • Remove the nine 6mm Phillips #00 screws that line the border.

  2. IRvkHp1aoqI5CyxA
    IRvkHp1aoqI5CyxA
    aKVyGerKYkgCL4vS

    • Remove the two rubber feet closest to the hinge using tweezers.

    • Remove the two 6mm Phillips #00 screws revealed under these rubber feet.

    • The rubber feet may tear while removal; preventing this can be difficult, but it won’t harm the laptop. If desired, replace these rubber feet during reassembly.

  3. LwgQFOUvVTgHQmfb

    • Flip the laptop so it is in the upright position.

    • Open the lid.

    • Unsnap the keyboard mount along the border of the laptop using a plastic opening tool.

    • This may require more force than expected. Hearing loud clicks as the plastic opening tool slides along the seam is normal.

  4. OyWy1LvdO12ZS4Ai
    OyWy1LvdO12ZS4Ai
    EETTmIjp6aXyiWw4
    w3kqSSplRh5kIxZi

    • Tilt the keyboard mount up.

    • Use a spudger to flip up the two ZIF connector retaining flaps for the ribbon cables that connect the keyboard mount to the motherboard.

    • Gently remove both ribbon cables.

  5. LFTxR4CXnvnHvpou

    • Lift the keyboard mount out of the laptop.

  6. noCKSQDXOjbNLvGU

    • Gently tug on the black and white wires connected to the Wi-Fi module to disconnect them.

  7. dRDlFTaBCyxPcDQJ
    dRDlFTaBCyxPcDQJ
    HPEKFuLj1AmdIxF2

    • Using a spudger, lift the ZIF retaining flap that secures the display’s ribbon cable to the motherboard.

    • Gently pull the ribbon cable out of its socket.

  8. EoPjZZUxl5Z4PHhC

    • Free the wire from the casing.

  9. aocScLOZybRtu1IZ

    • Remove the two 6mm Phillips #00 screws located near the upper left and right corners of the hinge mounts.

    • Hold the lid so that it is folded slightly inwards while removing the screws so that the lid doesn’t fall.

  10. RIg6I3YGM1fSFjaM

    • Rotate the lid to a 90-degree angle with the table.

    • Shimmy the lid out of the laptop.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Rahul Goyal

Mitglied seit: 26/04/17

1369 Reputation

0 Kommentare