Einleitung

In order to remove the bottom cover, you will need the nylon spudger and the Phillips 1 Screwdriver Head.

  1. PEtHivMAklACJTHZ
    PEtHivMAklACJTHZ
    JKaeeNlyIfNFjjVj
    spupGbTb6Rihpb6Y
    • Flip the laptop over to expose the underside.

    • Remove the two grip pads with blue plastic opening tool by inserting the tool between the laptop and the pads and slowly lifting up.

    • The grip pads are tacky, remove slowly to avoid separating the adhesive.

  2. WEMrMCpEI1iSt4Sm
    • Remove the two 8 mm Phillips Head screws that were under the grip pads using a Phillip's Head 1 Screwdriver.

  3. LWdwUjUJTR5UYSWT
    • Remove the six 5 mm Torx screws using a T5 Torx Screwdriver.

  4. mYwlgmKVDPXpu4nB
    mYwlgmKVDPXpu4nB
    jqMOrkUW6E6GuIBX
    NnK2nVGb44jMpLg4
    • Use the nylon spudger to pop off the bottom cover by inserting it into the heat vent and twisting to the left or right.

    • You may hear a slight clicking or popping, but that is normal.

    The case is secured by plastic hooks at 1” intervals. Use the nylon spudger and the opening tool to lever around the rim of the case. Start at the edge of the heat vent and work around the rim. Each plastic fastener will make a popping noise as they release.

    David Shorr -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Sarah Samora

Mitglied seit: 02/10/17

750 Reputation

4 Kommentare

what should I do if I don’t have a nylon spudger? Is it safe to use my fingers to pry it open? I know I need to be careful about static or else it could fry the comp.

Joshua Bowman -

It was really easy to open.

[deleted] -

Glad I read this…didn't know about the 2 screws under the grip pads. Once again the internet comes through.

MrHarris73 -

But where can i purchase the bottom cover

imran abdulhameed -