Einleitung

Use this guide to replace a faulty battery.

There are many reasons why you may want to replace your battery. The common issues are usually low battery life, battery not holding a charge anymore, or just simply the battery is completely dead.

Before replacing any parts on your computer please refer to the troubleshooting page which may give you some solutions on how to fix your battery issues before buying a new one.

Make sure all power is fully disconnected before the rear laptop cover is removed.

  1. UjqbeFEBgSrtoEPj
    • Make sure to power off the laptop before proceeding with the guide.

    • Turn the laptop over so the back is facing up. Use a Phillips #0 screwdriver to remove the 11 screws from the bottom cover. Rotate the screws counter-clockwise.

    • Eight 5mm screws.

    • Three 10mm screws.

  2. WPoeREnIauC1sqHJ
    WPoeREnIauC1sqHJ
    CiEXmEmDmNkhG6cg
    qWBK1uJL54Q5dEp4
    • Gently remove the CD-ROM drive by using a plastic opening tool and sliding it out of the laptop housing.

    • Using the opening tool, gently pry open the back panel of the laptop. Slowly work around the edge of the laptop with gentle pressure.

    • Remove the back cover from the laptop.

    Taking the cover off is probably the most difficult part of all this. The cover is fragile and probably easy to break if removal is not done properly. There should be more instruction on how to do this.

    Jim Rowan -

    Working along the DVD-rom drive side, and working along the back, and the full length side then lifting the back off seemed to work much easier than trying to ‘fight’ the front edge. Our factory sealed laptop had only 3 screws for the battery once we got underneath as well.

    Jagdt Mirage -

  3. cKHJvWUd3qTPsgAR
    cKHJvWUd3qTPsgAR
    dHmOo4lo5WNlxM5U
    ET2TAltqAlpwnwuf
    • Remove the six 5mm screws securing the battery using the Phillips #0 screwdriver.

    • Gently disconnect the battery from the motherboard with a plastic opening tool and remove it from the device.

    • If you're installing a new battery, you should calibrate it after installation.

    • Charge it to 100% and continue to charge it for an additional two hours. Next, unplug the charger and use the laptop normally to completely drain the battery. Wait at least five hours and recharge the battery to 100%.

    Hello,

    Can someone help me find the location of the CMOS battery in hp pavilion 15 cc005ni

    jean paul mbiya -

    There is no CMOS battery

    Gregg Stanley -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Frankie Guzman

Mitglied seit: 16/09/19

196 Reputation

Ein Kommentar

Bonjour, please, aidez moi, mon ordinateur HP Pavilion 15 cs00051 ne démarre pas, seule le voyant du bouton d'allumage et le voyant de charge clignotant continue

Spiritus Sanctus -