Einleitung

In this guide, you will learn how to replace your HP pavilion Sleekbook's Hard Disk Drive (HDD).

  1. 6dxudZaHIjoaYQ2l
    6dxudZaHIjoaYQ2l
    CqpJ3qROnNyFXxQW
    • Flip the computer over and move the battery lock switch to the "unlocked" position (marked by an orange lock icon).

  2. qor3KOHp5pgpHvBN
    qor3KOHp5pgpHvBN
    bZEgaDEuvmEiVvab
    • Press the switch on the right-hand side of the back of the device towards the center until the gray battery icon is no longer visible. This will eject the battery.

  3. 3touRGtSqQXCC5RN
    3touRGtSqQXCC5RN
    N1ALZLfAaEXa3FhY
    • Carefully pull the battery away from the device.

  4. EnfR5ckCLKoBDUPL
    • Using a Phillips #0 screwdriver, unscrew all eight of the screws.

  5. kyXAJlNxMPPCslLb
    kyXAJlNxMPPCslLb
    pcfi14RyMDu4CAQR
    6BgGShOVKILpyqHy
    • Using a plastic opening tool, pry up on the upper edge of the keyboard.

    • There is a wire connecting the keyboard to the motherboard. Do not pull the keyboard away until you have disconnected it.

  6. KHxdX3ceEpImuQra
    KHxdX3ceEpImuQra
    CqiFdDYQBfFv3gZP
    FobkfLrwwKj2YDYO
    • To disconnect the wire, pry up on the latch holding it in its socket.

  7. CBAmXBkoDbGStx5f
    CBAmXBkoDbGStx5f
    YL6lTYa2S4YPXc5p
    QotXirsTLqTQvDYD
    • Flip the laptop back over.

    • Using a plastic or metal spudger, carefully pry the top and bottom halves of the case appart.

    • Don't push the metal spudger in too far or you might damage the laptops internal components.

    • Do not pull the halves apart yet as there are still wires attaching them together.

  8. QEbBCFKeTpR1aR3j
    QEbBCFKeTpR1aR3j
    NOkRRVK6BLYFOc5j
    A2BZxM2Num4Hnuer
    • Disconnect the touch pad wire by flipping the small black lever using a plastic opening tool.

  9. awetGvXCvSlBSMNL
    awetGvXCvSlBSMNL
    chnUFXICsBEPsTCH
    • Unscrew the small circuit board underneath the power button.

    • Remove the circuit board by pulling up and away on the plastic tab.

  10. wyCNe2DHeAfhwcVs
    • Pull the top half of the plastic case off of the laptop.

  11. ic3wk2NdFpLEkCxp
    ic3wk2NdFpLEkCxp
    PFvxWXCDnWRubxWY
    xMJM6SxIHFxENYMD
    • Remove all seven of the screws using a Phillips #0 screwdriver and pull the plate off the motherboard.

    • There is double sided tape holding the plate down, as well as the screws. Sufficient force will be required to remove the plate.

  12. vKAYCkkbBfDIHcul
    vKAYCkkbBfDIHcul
    p6hqUPByEiLcIWbE
    • Remove the USB wire which runs over the top of the hard drive.

    • The wire is stuck to the hard drive with double sided tape.

    • Remove the wire by carefully pulling towards the USB connector on the left hand side of the laptop.

  13. V6H1aVcwCtJ5RUfP
    V6H1aVcwCtJ5RUfP
    vBAIEJkYPHQTQQSd
    • Remove the four screws securing the hard drive to the motherboard.

    • Disconnect the hard drive cable by gently pulling it away from the hard drive.

Abschluss

To reassemble your device, follow these instructions in reverse order.

James Barlow-Jones

Mitglied seit: 26/09/17

325 Reputation

0 Kommentare