HP Pavilion dv7t-7000 Motherboard Replacement

Geschrieben von: emmanuella Dickson-itua
  • Kommentare: 2
HP Pavilion dv7t-7000 Motherboard Replacement

Schwierigkeitsgrad

Moderate

Schritte

19

Zeitaufwand

30 - 50 Minuten

Einleitung

A replacement guide for the motherboard of the HP Pavilion dv7t-7000

  1. kYdpTiR1c1orUnDn

    • Turn the computer off and disconnect if from all power sources.

  2. AvXxwjFFQkZkxiJr

    • Slide the battery release switch to the left.

  3. EEAUpsH6fFrvnTjV

    • Hold the release switch all of the way to the left and your other hand to pull the battery out.

  4. o1ohOsCEGFMsQhZs

    • Unscrew the single Phillips #00 screw.

    • Screw will not come out, it is connected to the panel

  5. VoKGmu2gBdf5HGTp
    VoKGmu2gBdf5HGTp
    C4l3BPrKPTJEjxJQ

    • Remove service hatch by sliding away from the computer and lifting up.

  6. JVOsoPwFZq5jfDYK
    JVOsoPwFZq5jfDYK
    CVumHbRINxrJ2GVf

    • Remove the single Phillips #00 screw.

    • Flip the laptop over.

  7. x6PZVFAv3ob2TxYQ
    x6PZVFAv3ob2TxYQ
    MKskSxoR3ndZfJVE
    VYTWCLkW1KyA3bQ1

    • Wedge a spudger in between the keyboard and the upper bezel (nearest the screen).

    • Pry upward to release the keyboard clips.

    • The keyboard is plugged into the motherboard, so be careful not to pull out while lifting keyboard.

    The keyboard on mine had retaining studs on the palm rest side. Removing according to these directions broke the keyboard.

    Some keyboards may not have these.

    Peter K -

  8. qhXZqjeFQPee3NlG

    • Use the flat end of a spudger to flip up the black tab on the ZIF connectors.

    • Pull the ribbon cables out of the ZIF connectors.

    • Remove the keyboard.

  9. ALxSwKBX6GCracft
    ALxSwKBX6GCracft
    jm6udfWuqnmaxgQL

    • Push the retraining springs away from the RAM at the same time to unlock the RAM.

  10. GUttboMafXjiYsVj
    GUttboMafXjiYsVj
    wOo54XD1wecAvP25

    • Pull the RAM out.

    • Follow the same procedure for the additional RAM.

  11. sYI3FLBHFgAjnGxa
    sYI3FLBHFgAjnGxa
    FUPcgY3FLOgjUmvH

    • Use the flat end of a spudger to pop off the antenna connectors.

  12. CHDmq6kOwFUHTKnE
    CHDmq6kOwFUHTKnE
    12NWuWWNNXUJmWa2
    avG3dCKacDPaDxuN

    • Remove single Phillips #00 screw.

    • Pull the card out by hand.

  13. aafTYNNWMi1FPLI5
    aafTYNNWMi1FPLI5
    6wKBPXcR1LcBOtqN
    ccowuO4IUJQ3Jhlb

    • Flip the keyboard back over.

    • Remove the single Phillips #00 screw holding in the CD drive.

    • Pull out the CD drive.

  14. pOIjHRw3bQaGuY6H

    • Remove the seventeen Phillips #00 screws securing the back panel to the laptop.

  15. dcrjKdiTWWCvbZt2
    dcrjKdiTWWCvbZt2
    SLqZ2kdQS32rtjnc

    • Flip the laptop over.

    • Remove the single Phillips #00 screw.

  16. sPOmOrQDKT1HTZCi

    • Remove the panel by lifting it up.

  17. Dfh5Ty1GB4vG1Cn3

    • Remove the eleven Phillips #00 screws.

  18. 42yuMbPTDbe2r3Yx
    42yuMbPTDbe2r3Yx
    iux4JynR1r5C11Ed
    KBu3YVoAJK516YOk

    • Use the flat end of a spudger to disconnect all wires connected to the motherboard.

  19. G3aRBXyaZHvD5bHr
    G3aRBXyaZHvD5bHr
    uUyFYSSV3ptoRXE3

    • Lift up the black tab on the ZIF connector with the flat end of a spudger.

    • Pull the ribbon cable out of the ZIF connector.

    • Remove the fan from the laptop.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

emmanuella Dickson-itua

Mitglied seit: 21/02/18

121 Reputation

Ein Kommentar

Hello guys

I'm searching for a Bottom Base Case for HP Envy DV7 Pavilion

Does anyone know where to find it?

Ri Ma -