Einleitung

If you notice that your computer is starting to run slow or is unresponsive to certain commands, then it might be time to replace your RAM. RAM is the short term random access memory for your computer, and replacing it is a fairly simple process that does not involve any difficult steps. All it requires to replace is a spudger and a Phillips #0 screwdriver.

  1. NM4ApCRVJYTgZu1y
    NM4ApCRVJYTgZu1y
    Gan2IyByheLbOGtR
    • Slide the battery removal switch towards the center of the laptop until the battery pops out.

  2. KNP6GQkduG6LyarI
    • Remove the battery from the computer.

  3. PmKbYOPqIcXAQNFG
    • Unscrew the two 4mm Phillips #0 screws found in the surface panel.

  4. SRwNiOMIHv1ubHBy
    SRwNiOMIHv1ubHBy
    XUMSc3SZQrhuNmAr
    • Using the spudger, pry the surface panel off starting from the side where the battery was located.

    • Pry the remainder of the panel off by sliding the spudger underneath the panel and gently lifting.

    • Aim for the corners of the panel while using the spudger to methodically remove it without damaging it.

  5. FpNrSDZ2tCPKj6oN
    • Lift the pried surface panel off of the computer.

  6. ahqCVCtGy5Qq2ZHS
    • Push outwards on the two clips holding the RAM in place.

  7. P5arFSiYn1nINE3E
    P5arFSiYn1nINE3E
    EyKYIi4JeIuPSIEs
    • Slide the RAM out of its position in the opposite direction of the battery removal switch.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Kyle Dinunno

Mitglied seit: 20/03/19

377 Reputation

0 Kommentare