HP Pavilion x360 m3-u001dx Battery Replacement

Geschrieben von: Subhleen
  • Kommentare: 2
HP Pavilion x360 m3-u001dx Battery Replacement

Schwierigkeitsgrad

Easy

Schritte

10

Zeitaufwand

5 Minuten

Einleitung

The battery is defective if the power is draining quickly after a full charge, or doesn't receive charge at all. Then use this guide.

  1. gYjHTcKfxLLAZLso

    • Shut down the computer.

    • Disconnect the power and all external devices connected to the computer.

    • Working on your device while it is turned on may result in electric shock.

  2. SovjkqN66AjVjmjq
    SovjkqN66AjVjmjq
    ikon1NpYoVFHUbxW

    • Use a Metal Spudger and remove the rubber foot closet from the bottom of the laptop.

  3. xO2oIVxVihIMUncV

    • Remove all of the screws located on the bottom of the laptop:

    • 5 Phillips 2.4 x 5.7 mm screws

    • 5 Phillips 2.0 x 5.0 mm screws

    • Make special note of each screw and screw lock size and location during removal and replacement.

    “5 Phillips 2.4 x 5.7 mm screws”

    “5 Phillips 2.0 x 5.0 mm screws”

    I think the color for the sizes are mixed up, because the one near the screen bending part are the bigger ones, yet it says they are the “2.0 x 5.0 mm” but they are the bigger ones.

    If I’m wrong, tell me because I’m not sure if thats the ways they’re named because I’m not an expert at screw sizes.

    SomeRandomChild -

  4. Ol3BWZHvYObRMjw3

    • Turn the computer over onto its base, with the computer open and the keyboard facing upward.

  5. ySAp1JTGlC5IAsgH
    ySAp1JTGlC5IAsgH
    vJaw6GIZOCowQqxF

    • The keyboard is attached internally by clips. Use a small amount of force when removing the keyboard.

    • Use the Plastic Opening Tool to separate the keyboard from the base of the laptop.

  6. 6QdcixZ54hfSAaWW

    • Raise the keyboard slightly to access the touch pad and keyboard cables.

    • Raising the keyboard too far or with excessive force may cause damage to the keyboard, touch pad cables, or their connectors.

  7. 1aDcZCZsqdBRT4Vf

    • Disconnect the ribbon cables attaching the touch pad and keyboard to the system board (motherboard).

    • Using the Heavy-Duty Spudger lift up the plastic locks connecting the ribbon cable to the motherboard.

    • Use the blue plastic tab on the ribbon cable to pull it out from the lock on the motherboard.

  8. YOiNQ5J5dWZwvSgG

    • Lift the keyboard away from the base of the laptop.

  9. 2UAAkP1BlwGXK5Dx

    • Using the Phillips 00 Screwdriver, remove 6 Phillips 2.0 x 4.6 mm screws from the perimeter of the battery.

    • Make special note of each screw and screw lock size and location during removal and replacement.

  10. xVkeRCgIawPWdweb

    • Carefully lift the battery up from lower right corner and disconnect it from the motherboard.

Abschluss

Follow these instructions in reverse order to reassemble your device.

Tinte & Feder

Subhleen

Mitglied seit: 02/02/17

1268 Reputation

Ein Kommentar

Thanks for this easy step by step guide. The pictures were incredibly helpful!

azbeasleys -