HP ZBook 15 Screen Replacement

Geschrieben von: Grant Terris
  • Kommentare: 3
HP ZBook 15 Screen Replacement

Schwierigkeitsgrad

Easy

Schritte

6

Zeitaufwand

5 - 10 Minuten

Einleitung

Is the screen on your laptop malfunctioning? Here are some possible problems with your screen. If you determine that the screen needs to be replaced, follow this replacement guide!

  1. oUUsahBa2QJygRJM
    oUUsahBa2QJygRJM
    N1gkgc6vxlnCO4CW

    • Flip the laptop over.

    • Slide the lever with the battery symbol beside it firmly until the battery pops out.

    • Remove the battery from the laptop.

  2. QfWymaUM2awFePQI

    • Orient the laptop keyboard-side up.

    • Use tweezers to remove the adhesive covers for the screws.

  3. JAXrNkTgh1CSHVWM

    • Remove the two 6mm screws with a Phillips #0 screwdriver.

  4. nKPvFsvUMD3JEfqf
    nKPvFsvUMD3JEfqf
    r2blEdtBFDk2hIMs

    • Pull the bezel away from the screen.

    • Be sure to go one edge at a time! Do not pull hard on the corners as it may crack the bezel.

  5. moATyWLNtp41jwat

    • Remove the four 3mm screws with a Phillips #0 screwdriver near the corners of the screen to remove the display.

    • Be careful not to confuse any screws. They are close together and you may remove the back cover instead of the display.

  6. dIOg2oM5WHcyvuSQ
    dIOg2oM5WHcyvuSQ
    vxWQZaC2GHtObEbp

    • Do not peel the tape from the side closest to the bottom of the screen panel! This may rip out the connector's wires.

    • Gently lower the screen and lay it face down on the keyboard.

    • Lift the corners of the tape closest to the top of the screen and peel toward the center carefully.

    • Slowly pull the tape away from the sides.

    • Lift the tape and disconnect the screen connector.

    • You can leave the tape stuck to the cable connector and still be able to remove it.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Grant Terris

Mitglied seit: 31/01/15

2795 Reputation

3 Kommentare

Worked great! Only caution that I would add is that on one of the machines I took apart, the adhesive strip behind the bottom of the bezel stuck to the bezel and not the circuit board behind. I had to carefully slide my finger between the adhesive strip and the bezel to separate them. Once the bezel was removed, I was able to stick the adhesive back down. I think this laptop may have been exposed to some sort of liquid, so this may not be a common issue.

dwakefield -

My ZBook 15u g5 does not have any adhesive covers around the screen. How do I replace?

H B -

Hello can i replace my hd screen with another fhd one?

Mohand Almohands -