Einleitung
Werkzeuge
-
-
Flip the HP iPAQ HW6515 over with the screen facing down.
-
Take the back cover off by pressing on the small silver button while pulling back then up on the case.
-
Place the back of the case aside for now.
-
-
-
Unscrew the four outside screws using the T6 hexagonal star screwdriver.
-
Unscrew the inside middle screw using a Phillips 00 screwdriver.
-
-
-
Use the plastic opening tool to pry apart the covers along the bottom of the phone.
-
Slide the plastic opening tool along the seam until the two halves of the case separate.
-
-
-
Unplug the sensor wire that connects the two halves of the case before pulling the two halves apart. Not doing so will damage the sensor wire.
-
-
-
Use a 00 Phillips screwdriver to remove the three small screws holding down the motherboard.
-
-
-
Lift the black tab to a 45 degree angle.
-
Use a screwdriver to get under the tape and disconnect the tape from the black tab.
-
To reassemble your device, follow these instructions in reverse order.