HP w2216h Speaker Replacement

Geschrieben von: Patrick Aucoin

Kommentare: 3

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

20 Minuten

Einleitung

Is sound not coming out the speakers or is the sound distorted? You should replace the speaker's in the monitor.

Werkzeuge

Schritt 1

'Make sure you are grounded, the power supply is not connected and you are wearing safety goggles.
Use the Philips #000 screwdriver to remove the 4 round12mm screws on the back panel.

Schritt 2

Using a Philips #000 head remove 2 flat 12 mm screws above stand mounting bracket.
Using a PH1 Philips head with the 150 mm flexible extension remove 1 Philips head screw under the stand mounting bracket.
Stand will easily pull off.

Schritt 3

Do not put the metal spudger between the metal and the glass. It needs to go under the bezel and above the metal.
Turn monitor so that the screen is facing you.
Pry the black bezel from above the metal by placing your metal spudger between the bezel and the metal and twisting the tool slightly.
The best places to pry are in the lower left and lower right corners of the black bezel.

Schritt 4

Be careful of the wires attaching the power button and the control buttons. Show extreme caution to ensure the button is not damaged.
Lift the screen assembly from the plastic housing from the corners.

Should it be "underneath one of the device's corners"?

Daniel Servant - 22/04/16

You might want to add a note letting users know that they should be careful of the wires attaching the assembly to the housing.

Daniel Servant - 22/04/16

You may also want to note that the card for the power button slides out when you lift this assembly so the user might need to be told to slide the card back into its slot when installing the new screen. ( A picture of this would be a good idea)

Daniel Servant - 22/04/16

Schritt 5

Remove the 4 connectors from the left side of the monitor on the back.

Schritt 6

Lift the gray tape of the top of the monitor to expose the ribbon cable.
Remove the ribbon cable by sliding the connector towards the center of the screen assembly.
Lift the reflective tape next to the gray tape.