Einleitung
Be sure to keep the processor unplugged throughout the replacement process.
Werkzeuge
-
-
Using a #2 Phillips head screwdriver, remove the two 11 mm screws from the base.
-
Pull suction cups straight out.
-
-
-
Remove rubber caps using the heavy duty spudger.
-
Remove the four 11 mm screws using the #2 Phillips head screwdriver.
-
Pull base straight out.
-
-
-
Cut all four red wires using the wire stripper crimping tool.
-
Using the wire stripper crimping tool strip the ends of each red wire and insert them into a new wiring connector cap, then crimp firmly.
-
Cut the white wire using the stripper crimping tool.
-
Using the wire stripper crimping tool strip the ends of each of the white wires and insert them into the opposite ends of a parallel connector, then crimp firmly.
-
To reassemble your device, follow these instructions in reverse order.
2 Kommentare
On our unit the control knob became stuck. Where can I get a new control knob? Do you happen to know the part number?
I used a hair dryer and that did the trick, but am wondering if WD 40 would work as well. I went online e with the company and they want $2.00 for tech advice which is dumb to me. At first I thought it was the locking device on top; it is actually the pulse switch and my machine is just over a year old.