Handset Replacement

Geschrieben von: Caleb Thomas
  • Kommentare: 0
Handset Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

4 Minuten

Einleitung

Prerequisite Only

  1. XbnLHRb2btWJ2gFr
    XbnLHRb2btWJ2gFr
    tRrunBKS4TgZp3MR

    • Remove the battery cover by placing your thumb on the cover and gently push towards the base of the phone.

  2. QWLqyWMjWCRDXXrU

    • Remove the rechargeable battery pack (BP-T18) by pressing down on the power cable connector and pulling at the same time.

  3. gbRVR4XeEOevMZwV

    • After removing the BP-T18 battery pack, you will see two 11mm Phillips #0 screws located at the bottom of the phone. Remove both screws with a screwdriver.

    • Product is made of brittle plastic.

  4. B2IgtAYwkjklB1yM
    B2IgtAYwkjklB1yM
    BygkQ5YVTDDtXTlR

    • Locate an easy point of access for a spudger, and then slowly insert it into the gap and pry it open.

    • The opening should become bigger if you exert force at a 30 degrees angle.

    • Increase the degree of slant until the back cover is completely removed.

  5. IigkDYhY2bm1M1kf
    IigkDYhY2bm1M1kf
    kvqmTOPCtMFndfaJ

    • After removing the back cover, you will see 3 screws: one 7mm Phillips #0 screw at the top and two 11mm Phillips #0 screws at the bottom.

    • Use a screwdriver to remove all 3 screws.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Caleb Thomas

Mitglied seit: 29/09/16

161 Reputation

0 Kommentare