Head Strap Removal

Geschrieben von: Sam Omiotek
  • Kommentare: 0
Head Strap Removal

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

Keine Schätzung

Einleitung

This is a prerequisite-only guide! This guide is part of another procedure and is not meant to be used alone.

  1. LnRydVZX5GycMC3o
    LnRydVZX5GycMC3o
    mPWInBOiUxUoIWHk
    32lhPiKJihIMHrPC

    • Peel off both front side foam pads to uncover the speaker wires.

  2. MM2PomssV1GIH2k1
    MM2PomssV1GIH2k1
    hTtmb141iJw5OJFm
    ZAfuS6wZT1FGWjtG

    • Insert the pointed end of your spudger behind the square rubber spacer next to each headphone screw.

    • Gently pry the rubber spacers out of the head strap.

    • Be careful not to accidentally pry any of the speaker wires under the rubber spacer.

  3. CVbX4PPWpfuB3Lev
    CVbX4PPWpfuB3Lev
    gTHLVQVxN2kPBLhD

    • Use the pointed end of your spudger to pry up and disconnect both the left and right headphone speaker wires.

  4. jyvLOIRiavsuSgk3
    jyvLOIRiavsuSgk3
    sAPbTeRiI1VYx2yZ

    • Use a T6 Torx screwdriver to remove the two 12.1 mm screws (one on each side) securing the head strap to the headset.

    • Use a T5 Torx screwdriver to remove the following screws securing the head strap to the headset:

    • Four 3.9 mm screws (two on each side)

    • Two 4.1 mm screws (one on each side)

  5. 2KDUshEaMsb6IDTc

    • Remove the two plastic spacers underneath the previously removed screws from the headset.

  6. sIRdYNZpryGVtKfP
    sIRdYNZpryGVtKfP
    bPQpTY5jgpl5qIYQ
    U6AlJRrlhEUijfEP

    • Thread the headphone speaker wires out through the ends of the head strap.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Sam Omiotek

Mitglied seit: 25/02/19

59342 Reputation

0 Kommentare