Hover-1 XLS Ignition Replacement

Geschrieben von: Jonathan Hidalgo
  • Kommentare: 0
Hover-1 XLS Ignition Replacement

Schwierigkeitsgrad

Moderate

Schritte

3

Zeitaufwand

5 - 10 Minuten

Einleitung

The screws in the front panel are coated in Teflon, making them harder to unscrew. To make the screws easier to remove, you should apply a Blaster onto the screws and let the blaster settle in for about two minutes.

  1. J4QORQnPhTXLxU4h

    • Remove the six 16mm #3 Hex head screws located on the front panel.

    • The screws are held in with Teflon tape, so use a chemical remover like B'laster to loosen the screws.

  2. 1ABEjf1GdGwtVUMq
    1ABEjf1GdGwtVUMq
    pYrJSDQFYpoMyr14
    JZHaRJpH2MVedjXK

    • Grab the front panel and gently lift it up to the side.

    • The front panel is connected to the ignition, so don't pull too hard or the wires will get damaged.

  3. JcSUKoqciYUmy4kE

    • Remove the two, 19 mm Phillips #2 screws holding the ignition.

    • Remove the yellow and red wires that are connected to the ignition. To remove them, look at the soldering guide provided by iFixit.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Jonathan Hidalgo

Mitglied seit: 24/01/19

575 Reputation

0 Kommentare