Einleitung

Use this guide to open the GuliKit KingKong 2 Pro controller for repairs and modding.

  1. U4Nrl5tNANSaohOE
    • Use a Phillips #00 screwdriver to remove the four 11 mm-long screws securing the back cover.

    Hi, do you know what size screw is used for the outer portion? mine is stripped and i need to buy a new one

    Kevin Dimas -

    What you should use is a PH #0 Screwdriver, not a PH #00

    Yamatoklok -

  2. 4t5vaEkQAXGRo4hI
    4t5vaEkQAXGRo4hI
    6lUsZPPxiGFoWCey
    • The back cover of the GuliKit Kingkong 2 Pro is held in place by plastic clips.

    • Insert an opening pick into the gap between the front assembly and the back cover at the bottom edge of the controller.

    • Tilt your opening pick downwards to widen the gap.

  3. IvVFAaDOIQUiEHBJ
    IvVFAaDOIQUiEHBJ
    eIRQjRCoOywgKyLn
    • Insert an opening pick into the gap between the front assembly and the back cover at the outside of the right controller handle.

    • Slide the opening pick along the gap to separate the front assembly from the back cover.

  4. Qndkw5TYTOrOCZFu
    Qndkw5TYTOrOCZFu
    Sb6u11Dd5eWQFPxv
    • Insert an opening pick into the gap between the front assembly and the back cover at the outside of the left controller handle.

    • Slide the opening pick along the gap to separate the front assembly from the back cover.

  5. UWSlp65iZQ6OQH5C
    UWSlp65iZQ6OQH5C
    KWdSHPQ3GAyERcja
    • Separate the back cover from the front assembly and remove it.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Take your e-waste to an R2 or e-Stewards certified recycler.

Repair didn’t go as planned? Check out our Answers community for troubleshooting help.

Dominik Schnabelrauch

Mitglied seit: 23/11/16

167866 Reputation

0 Kommentare