Huawei P40 Lite Screen Replacement

Apply a little heat around the base then, using a suction cup, lift the screen up sufficiently that you can place a pick between the screen and the case.

The adhesive is very light and the rear is plastic so it is unlikely to break.

As well as the adhesive around the outside of the screen, there is adhesive around the camera which will also need to be heated and separated from the body of the screen.

Remove the 10 Phillips 00 screws including the one covered in a white piece of paper.

Using a spudger lift up the battery connector, being careful not to damage the surrounding circuitry.

Peel the black plastic from the battery. The adhesive here should be very light.

I REALLY HATE HUAWEIs PULL TABS! (Just wanted to get that out my system)

Peel back tab 1 and 2 until they are no longer in contact with the battery

Peel back tab 3 and lift up.

You must be patient and careful so as not to deform the battery.

You may need to use a pick under tab 3 to leverage the battery out.

Use a spudger to disconnect the screen connector from the motherboard and lift the cable from the adhesive.

Apply heat to the edge of the screen and, using a suction cup or blunt scalpel, work a pick under the screen

PLEASE NOTE THERE IS A PLASTIC FRAME BETWEEN THE PHONE CHASSIS AND THE SCREEN.

Make sure your pick is between the screen and the frame and not the frame and the chassis.