IBM ThinkPad T41 RAM Replacement

Geschrieben von: Marissa Blustein

Kommentare: 3

Schwierigkeitsgrad

Moderate

Schritte

Zeitaufwand

10 - 15 Minuten

Einleitung

This simple repair guide will aid you in taking apart your IBM ThinkPad T41 laptop to reach and replace its RAM.

Werkzeuge

Schritt 1

Close the screen and turn the closed laptop over.
Remove all 17 screws on the bottom of the computer.
The multiple colors (turquoise, red, blue, orange, yellow, and purple) are for organizational purposes, indicating different screws.
The yellow marker at the rear denotes the UltraBay device retaining screw. This screw is optional as the UltraBay mechanism will hold the drive or battery in place anyway. The yellow marker at the front denotes the hard disk caddy retaining screw.

You need to remove the battery, hard drive, and UltraDrive before starting step 1.

cak - 01/10/14

Schritt 2

Remove the extra RAM cover, by lifting where the screw was and pulling out.

If there's extra RAM under the cover, remove it by spreading the retaining clips.

cak - 01/10/14

Schritt 3

Turn the laptop right side up and open the screen.
Lift the keyboard, using a spudger at the seam between the keyboard and trackpad.
Careful of the ribbon cable underneath, which may tear if the keyboard is lifted too vigorously.

Schritt 4

Unplug the keyboard’s ribbon cable, by lifting up the edges of the plug.
Remove the keyboard.

Schritt 5

Push apart the retaining clips on the RAM.
Note: The RAM should pop up a little bit.

Schritt 6

Lift out the RAM chip.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Ein Kommentar

You only need to take out 4 screws on the bottom of the laptop that have a picture of a keyboard beside them to remove the keyboard. I don’t know why the tutorial says to take out all the screws. Other than that, great article.

Gary Thurman - 07/12/19