Infant Optics DXR-8 Speaker Replacement

Geschrieben von: Larsha Johnson
  • Kommentare: 8
Infant Optics DXR-8 Speaker Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

15 Minuten

Einleitung

Replace a faulty speaker.

  1. GOcvjwfgMcdXpsse
    GOcvjwfgMcdXpsse
    ZsNhD23SUDoHGrU5
    jT1ghDUBpspqWsjW

    • Using the plastic opening tool, remove screen protector from front of monitor.

    There's a layer of adhesive between the screen protector and the white plastic behind it.

    Jared Astillero -

    The cover is glued on. So you’ll nee d quite a bit of force to bend it up. But then it’ll come lose glue point by glue point. At first I was afraid that I’ll break it.

    Marco Smolla -

  2. N5QZknKvCQOlQXcL
    N5QZknKvCQOlQXcL
    GhBMVduKGErGhmVM
    lI14wgJlKmQ6WYFx

    • Remove the six 4mm screws using a Phillips #00 screwdriver.

    • Remove the screen, exposing the circuit board.

    • Turn device over to expose rear circuit board.

  3. eZKvBkxC6t3jITrS
    eZKvBkxC6t3jITrS
    PhVBd2P6MqTojxIG
    dGHmHmoHMHY1YTkv

    • Disconnect speaker from monitor for ease of access by unplugging wire.

    Thank you so much for this - and thank you to the commenter who walked through the additional screen replacement steps! I’ve never done anything like this and I managed to replace the screen myself.

    Lauren Skinner -

  4. yfv2HQi5xHRwlCDZ

    • Use a heat gun to soften and easily remove epoxy that surrounds the speaker. Gently scrape it free little by little with metal spudger.

    Be more specific about how to remove the speaker. Explain how to soften the adhesive, etc. Make sure you point out which tools to use when removing the speaker. How do you grasp it?

    Patty Remmell -

  5. lbEvSYwDIAYYd3oD

    • Lift the speaker from casing using metal spudger.

    • Place new 8W speaker in the casing and connect wire.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Larsha Johnson

Mitglied seit: 27/08/15

484 Reputation

4 Kommentare

Where to purchase the replacement speaker?

Keiundra Joiner -

Where can we purchase the replacement 8w speaker part

lea placek -

8W Speaker is incorrect.

The speaker needed is 8 Ohm 0.5 Watt.

Ryan Ernde -

This is good to show how you get it open. Unless you have a speaker that has the plastic piece that connects to the mother board, then it’s useless. The speaker I ordered just had two free standing wires.

Mark Ruddy -