Infinity v2 10.1 Camera Replacement

Geschrieben von: sammytarbokas
  • Kommentare: 0
Infinity v2 10.1 Camera Replacement

Schwierigkeitsgrad

Easy

Schritte

4

Zeitaufwand

10 Minuten

Einleitung

The Infinity v2 10.1 camera should be replaced when it no longer turns on, the lens is cracked or water damaged, or when it takes a distorted image. Replacing the camera is a simple process, without any previous repair experience required. You will simply disconnect the camera from the motherboard, which you can do using your fingers. All you will need is a tool to open the device and a new camera to replace with the old one.

  1. MbTyY4IiXhQ1Xdtc
    MbTyY4IiXhQ1Xdtc
    VVFNdoEJAMLXMSQT
    f5UnSnWwZyND4GQR

    • Slightly pry open one corner of the device by using your finger nail to separate the screen from the back case.

    • Use an opening tool to carefully detach the back case from the tablet. Start by inserting the tool where your fingernail opened a gap, and work around all four sides of the device.

    • There will be a slight click noise as you free each tab.

    • Once the case is completely free, carefully lift it and place it face up on the workstation, being cautious not to damage the speaker wires connecting the two halves.

  2. FbD1eBpGgWIDnpHQ
    FbD1eBpGgWIDnpHQ
    h5nDOKMT3PE6cKy4

    • Remove the speakers from the case by gently lifting them up and out of their slots.

  3. xNAZmhQVovDuG31J

    • Use your thumb or opening tool to lift the black connector holding in the ribbon cable.

  4. GhXympglVbEJGy2d

    • Remove the camera by gently picking it up and pulling it free from the connector.

    • Avoid touching the lens of either camera.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

sammytarbokas

Mitglied seit: 31/10/19

193 Reputation

0 Kommentare