Einleitung

Der JBL Charge 3 hat zwei Frontlautsprecher, die einzeln oder zusammen ausgetauscht werden können. Diese Anleitung zeigt dir, wie das geht

  1. iM4oEbSJvrCv1M42
    iM4oEbSJvrCv1M42
    hVTHnK2ZHk6WYCZD
    UQOa1JkUcJXahQCK
    • Lege dein Gerät mit der Unterseite nach oben und setze ein Plastiköffnungswerkzeug vertikal in den Schlitz in der Frontabdeckung ein.

    • Ziehe das Werkzeug langsam nach außen und löse die Rasten, mit denen die Abdeckung befestigt ist.

    • Wiederhole dieses Verfahren an allen vier Kanten der Frontabdeckung.

    Sometimes disassemblers forget that the first time they disassembled the item it didn’t want to give up easily: I didn’t like the forces I was having to apply at all, so I switched to two plastic prying tools per “corner” and one in-between them (total 5, you could use plectrums…) before I was happy the the forces were low enough not to break anything.

    Frank Puranik -

    the front grill is supposed to be first not the back the back has longer while the front has shorter clip

    Water Bass Tester (Water BT) -

    There are two Phillips head screws to remove before prying the cover off

    jason -

    Where in south Africa can I buy jbl charge3 port bay replacement

    Donovan Fransman -

    There appears to be different versions of the Charge 3. If you find it difficult to pry open a second side the two small screws mentioned by Jason will need to be removed but it also indicates that there will be some additional changes to this tear down that I will try to convey in the comments as well.

    john Ramirez -

    Sadly I damaged the latches on my charge 3. There was more to it than just prying the front cover up. First, there is a small latch on both sides that you need to push down before pulling the front cover towards you that release the clips holding the front cover in place. Pull only slightly forward because… Second, in the front cover there are 6 circular notches connected to the front cover in tue four corners including the middle corners, you need to squeeze the front cover a little bit gently removing the notches so they dont break (like mine did).

    ralphkeneth_gomz -

    Definitely had to watch about 10 videos and still couldn’t get it to pop out easily.. Took a look at the first picture in the next step and really took note of where the little hole that lets you through to push down the tab is. Once I took a look at that and combined the techniques I’d seen in some of the videos it finally popped off easily. https://www.youtube.com/watch?v=u7i0_nD9... I only watched the first minute of this video but it helped a good bit if anyone else is having trouble.

    Rowan Darko -

  2. dVS6cpIOfmgGM33C
    • Ziehe die Abdeckung auf beiden Seiten vorsichtig auseinander und entferne sie vom Gehäuse.

    • Im Inneren der Frontabdeckung befinden sich Löcher, die beim Zusammenbau in die entsprechenden Stifte des Lautsprechergehäuses passen müssen

    • Das Entfernen der Frontabdeckung beeinflusst nicht die Abdichtung gegen Feuchtigkeit. Allerdings werden beim weiteren Zerlegen des Lautsprechers wasserdichte Verklebungen und Dichtungen beschädigt. Dein Gerät wird danach wahrscheinlich nicht mehr länger wasserfest sein.

    Include dissembling the plastic cover? cover?

    KanGoon -

    @KanGoon Yes, on mine it took the removal of 6 (reasonably obvious) screws to remove that. I’ll try to insert a photo when I reassemble…

    Frank Puranik -

    Very good guide! Pics and descriptions make this easy!

    John G Petko -

    There is a step missing here. How do you remove the rubber cover that covers the port?

    Phillip Luebke -

    Gibt es eine Möglichkeit diese wieder wasserdicht zu bekommen?

    Furkan Karakelle -

  3. 4YvACn42HGMRj6gb
    4YvACn42HGMRj6gb
    3UH1Qhe5QckNrbcS
    • Entferne die acht 10 mm Kreuzschlitzschrauben #1, mit denen die beiden Lautsprecher befestigt sind.

    Die Frage : Ist ob man irgendwo Ersatz Lautsprecher bekommt ???

    nicowihnaleck -

    Probier's mal hier, vergleiche aber ganz genau (Seriennummer GG…):

    https://ecommerce.mysav.eu/en/jbl/147-sp...

    VauWeh -

  4. XvEELa1kEJEh5ZdX
    • Ziehe sorgfältig einen der beiden Lautsprecher heraus. Sei vorsichtig, er ist immer noch an der Hauptplatine angeschlossen.

  5. p2H2LRICOfBVbXMF
    p2H2LRICOfBVbXMF
    VKZCjNbMvBQANonR
    GT1KIIxBy1UoaPhJ
    • Im Flachstecker des Lautsprechers ist eine kleine Metallverriegelung. Drücke sie mit einem Schraubendreher hinein und ziehe den Stecker vorsichtig ab.

    Where can l buy those speaker for replacing

    Terrence Terrence -

    Somebody know where I can buy These speakers ?

    motje -

    The speakers that is on my charge 3 is soldered on doesn’t have the clips in picture

    travenature -

  6. 2TUL2HWqdaRQZ5i1
    • Wiederhole diesen Schritt für den zweiten Stecker.

  7. Wt6afYjaeG6pNhYA
    Wt6afYjaeG6pNhYA
    uAMtFoZ3IYVTGP51
    • Fasse den Stecker am Kabelbündel, welches die Lautsprecher mit der Hauptplatine verbindet, mit einer Pinzette an. Ziehe den Stecker vorsichtig ab.

  8. Utyb6hCmCblWHQ6P
    • Nachdem der zweite Lautsprecher von der Hauptplatine abgetrennt ist, kannst du ihn und seine Anschlüsse herausziehen.

    where can i buy these speaker,i need to replace the left side speaker because it was already damaged

    geoffrey mustar -

Abschluss

Um dein Gerät wieder zusammenzusetzen, folge den Schritten in umgekehrter Reihenfolge.

Aidan Hays

Mitglied seit: 08/10/18

3097 Reputation

28 Kommentare

Where I can buy the same jbl speaker ?

Ekinox -

I need to replace my JBL charge 3 speaker

Lara Esther -

Where can buy the small speakers? Helpp

Luis Cilia -

I have to pull out the motherboard to get those speakers out.

Tr0ll05aur0s 3z -

where can i buy the replacement speakers?

Yhamani Pangarungan -

Mine did not have the little clips in step 5. It was just soldered on. I ended up removing it from the other end. At the little white clip that goes in the motherboard (shown in step &) I was able to remove the pin. by pressing down on the top where you can see the silver.

Mike -

It doesn’t seem possible to buy replacement speaker units.

dave -

I see them on ebay, there are two designs. Btw, my speakers don't have clips, they are soldered on.

Erwin Johnson -

i just completed this repair using generic replacement speakers from ali express item number 32829635211

mine were soldered on. i had to trim 4 orientation posts that prevent the factory speakers being installed rotated incorrectly, as these wouldn’t work with the new speakers. they sound OK, but have noticeably less bass than the OEM JBL drivers and can sound a little more tinny. there are also people doing it on ebay for 30$, but i am not in the USA so that was not convenient.

ivan@absolutehid

ivan -

Where can I buy these same speakers

Silvester Whitehurst -

San mkabili ng orig.na speaker ng jbl3?

rodolfom.afan -

where I can buy these speakers. also need it for India region . but as I checked not able to buy it .

Prince Gupta -

Contact JBL customer service if y3have or gen get the teveipt call them and then email pic8or the receipt ant the JBL Serial number by the speakers when the blabk jbl grill is off if less than 12 months old youll get a free speaker replacement if out warranty or you have no receipt the replacement speaker for Charge3 is only $32.19 USD. Good luck.

David Lorince -

Contact JBL customer service if you have a charge 3. get the customer service number, call them and or then just email description fate SN# and pic of the receipt and the JBL Serial number between the speakers when the black JBL grill is off, but only if its less than 12 months old then you’ll get a free speaker replacement if out warranty or you have no receipt the replacement speaker for it is cheap only the JBL Charge3 is only $32.19 USD. Good luck.

David Lorince -

If you can find a cheap replacement battery for $20 grab it cause its totally worth it if out in the wilderness it also acts as a cellphone charger.

David Lorince -

Fyi upset neighbors since my left charge 3 is blown i decided it daisy chain 3 50 wayt pyle horn tweeters omg lets just day its about 500p% louder. Lol. Happy 4th of

David Lorince -

Do you have a specific link for this OEM JBL charge 3 speaker replacement or are you just directing us to the JBL company where they currently want $35 + shipping on a single speaker unless the Charge 4 and Flip 4 lower these crazy prices. Has any one found a similar Charge 3 speaker replacement that’s louder and cheaper ???

David Lorince -

For anyone that is wondering where to buy the speaker replacement, you can find it on all express just search up JBL charge 3 speaker replacement.

Armin Aghayan -

Absolutely ridiculous how much replacement speakers are! I found some that “work” but they sound like crap…… Considering I have 4 Charge3’s and 1 Charge4, Harmon already has PLENTY of my $$!

Sheldon Abbey -

JBL Charge 3 -

vorrei acquistare la coppia di casse uguale modello e dimensioni potreste fornirmi l’articolo a il link x ordinarli grazie

I would like to purchase the pair of speakers of the same model and size, could you provide me with the article at the link to order them, thank you

roberto -

Ciao @flipok ! Maybe you can find some options in this Answer on our Forum: Where to buy replacement speakers for JBL Charge 3? Good luck!

Claire Miesch -

In accurate info unless they change how they put it together later down the road

travenature -

good dayhouse pls where can i buy replacement speaker for jbl charge 3 and battery any body with information thanks

EMMANUEL JUNIOR -

I've ordered one. I will update after installation is done.

Rich Buffetta -

Simple install. Youll need a soldering iron, some solder and a smallish phillips. Works fine now for about 10 bucks from ali.

Rich Buffetta -