JD Razor 2000 Handle Bar Replacement

Geschrieben von: Kevin Church
  • Kommentare: 1
JD Razor 2000 Handle Bar Replacement

Schwierigkeitsgrad

Easy

Schritte

3

Zeitaufwand

10 Minuten

Einleitung

The JD Razor 2000 scooter features two soft-grip handle bars that are each attached to the T-Bar by a fastening button as well as a continuous string with stoppers at each end. This guide will show how to replace a handle bar.

  1. rcESlm1XbWOG32xK
    rcESlm1XbWOG32xK
    UWNM5SVVYtrDPUaM
    l6xEUBQVjCwSsOxE

    • Firmly hold the handle bar in place.

    • Grab with one hand the black removable tip of the handle bar and pull it out.

    • Pull out the end of the tied string through the removable tip.

  2. vLIkSMEJcbbBeRy3
    vLIkSMEJcbbBeRy3
    w6efALtGwTFOCsJM

    • Untie the knot at the end of the string.

    • If you let go of the string while its in tension, it may recoil far into the other side of the handle bars. To avoid this, bring the end of the string inward towards the hollow section of the handle bar and then carefully let it go.

  3. FKRbPLjrDQM3HjLk
    FKRbPLjrDQM3HjLk
    MqgobNGXyI43WW4C

    • Press down firmly on the golden fastening button located on the handle bar being replaced.

    • While still pressing down on the fastening button, slide the handle bar apart from the T Bar.

    • When re-installing the handlebar (after completion of the guide), you may need a pair of needle-nosed pliers to thread the string back through the handlebar.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Kevin Church

Mitglied seit: 17/10/14

297 Reputation

Ein Kommentar

Why is the stretchable string for?

dantotford -