Einleitung
Is your Keurig K55 K lid not staying open? If so, you might have a broken or missing spring. Here's a guide to replace the Keurig K55 Lid Spring.
Werkzeuge
-
-
Lift the silver handle up.
-
Locate the screw and washer holding the handle in place on each side.
-
Remove both 13mm screws and washers using a Phillips #0 screwdriver.
-
-
-
Grab the handle and pull it upward and toward the rear of the device.
-
Lift the lid to the fully open position.
-
Remove the two 11mm Phillips screws located on the upper part of the device.
-
-
-
Lower the lid to just before its closing position.
-
Grab the black top cover with the Keurig logo and gently push back toward the rear of the device to release it.
-
Gently pull the top cover upward and toward the front of the device to remove it.
-
-
-
Remove the two 11mm Phillips head screws securing the water pump.
-
Grab the secondary water pump firmly and pull one of the plastic water lines off of the pump.
-
Pull the other line from the water pump.
-
To reassemble your device, follow these instructions in reverse order.
