Keurig Mini B-31 Top zerlegen

Geschrieben von: Andrew Adriance

Kommentare: 12

Schwierigkeitsgrad

Mittel

Schritte

Zeitaufwand

Keine Schätzung

Einleitung

Werkzeuge

Kreuzschlitzschraubendreher PH1

Schritt 1

Öffnen den oberen Deckel der Keurig.
Ziehe einen der Arme, die den oberen Deckel festhalten, direkt nach außen. Es wird etwas Kraft erfordern, den Arm vom Stift zu lösen. Sobald eine Seite ab ist, wiederhole den Vorgang am zweiten Arm.

This step isn’t necessary.

Senior Senior, Jr. - 22/01/19

Thank you!! Since I sure cldnt get both arms to come off!

shari_thompson1 - 03/02/19

I cannot get the arms to come off at all!

Susan Klipfel - 13/02/19

Schritt 2

Lege die Keurig auf die Rückseite, sodass der Wassertank von dir wegzeigt.

Schritt 3

Halte Abstand von der oberen Nadel, sie könnte in deine Hand stechen.
Entferne die beiden 9 mm PH1 Kreuzschlitzschrauben, mit denen die obere Kunststoffabdeckung befestigt ist.

Schritt 4

Stelle die Keurig aufrecht so hin, dass die Vorderseite in deine Richtung zeigt.
Ziehe die Abdeckung von der Oberseite der Keurig ab. Sie sollte sich einfach, mit wenig Kraft abnehmen lassen.

Not coming off easily. Pull toward front a little helps.

Henry Huang - 22/10/16

There are two plastic latching tabs that hold down the back of this cover, about 5/8 inch in from either side. It should be possible to locate them by probing along the back parting line with a thin-blade screwdriver and release them by pressing forward. Or apply excessive force like I did and break them off.

Lytle Johnson - 02/03/18

Thx for warning, Lytle!

shari_thompson1 - 03/02/19

I have been pushing and pulling on that back side - Canby release those tabs. Anyone have a little more advice? Using a small thin blade knife…

wow8kids - 21/02/19

Schritt 5

Greife den Schlauch fest und ziehe ihn von der Kunstoffdüse ab.

Before pulling, you can see if this portion of the tube is clogged. If clogged at the other end, you may be wasting time going further. See comments at the last step.

Henry Huang - 22/10/16

Maybe, but it’s unlikely to be the case. The transition from roomy hose to cramped needle outlets is where syphoned up coffee grounds get caked up. And you might not see it. I squeezed the hose at the union a few times and that made black crud come loose. A visual inspection only would not have shown that.

Senior Senior, Jr. - 22/01/19

Our unit's hose end was secured with a plastic zip tie that had to be cut off. When replacing the hose, a new zip tie was required.

M A - 14/05/17

DO NOT cut it. Just slide the zip tie with your fingers. Then when reattaching the hose, put on hose first then shimmy zip tie back over union.

Senior Senior, Jr. - 22/01/19

Thanks so much Sr Sr Jr for both comments here!

shari_thompson1 - 03/02/19