Kindle Fire HDX 7" Micro USB Charging Port Replacement

Geschrieben von: Blake Klein
  • Kommentare: 2
Kindle Fire HDX 7" Micro USB Charging Port Replacement

Schwierigkeitsgrad

Moderate

Schritte

8

Zeitaufwand

30 Minuten - 1 Stunde

Einleitung

Replacement guide for the micro USB charging port on a Kindle Fire HDX 7” tablet.

The home button and micro USB are part of the same ribbon cable and are replaced at the same time.

  1. gxoRiHhEOixXuexo
    gxoRiHhEOixXuexo
    QCdpcKS6dLTSEsBj
    cOYVVwypVVOURgU3

    • Insert an opening pick underneath the speaker bezel, and slide it along the perimeter to separate it from the tablet.

    • The adhesive is strong and may require an iOpener, or heat gun, to soften.

  2. YZQpowUT4UKB2PT5

    • Remove the speaker bezel.

  3. chnPZTYvwdvqU4lm

    • Remove the six pink 3mm T3 Torx screws from the back case.

  4. M2u6tqVyPxkZbHvJ
    M2u6tqVyPxkZbHvJ
    nFJCsveAvlXQHdWx

    • Wedge opening picks around the perimeter between the display and back case.

    • Work the opening picks around the perimeter until the two halves disengage from each other.

    • Don't completely separate as the display ribbon cable still connects the two.

  5. v4AJDtcKpWR6vEyJ

    • Use the flat end of a spudger to pry up and disconnect the rear panel press-fit connector from the motherboard.

    So I don’t remove the MLB?

    pckeeler7 -

    When re assembling the press fit connector will not stay in place when trying the shut the case, it seems too short.

    Is there a nack or trick to doing this please?

    Carl Purser -

    • There may be a glue strip between the battery and the outside case. Gently pry the case open and use the flat end of a spudger to separate the glue strip.

  7. aUmsCWMQ6MOOF1CZ

    • Remove the four 2.3mm T5 Torx screws from the micro USB port and power button assembly.

  8. OMyHCpp1YOFfcSkJ
    OMyHCpp1YOFfcSkJ
    mwSFCIQnIo3FfXbn

    • Pry up the ribbon cable from the rear panel with the flat end of a spudger.

    • Remove the micro USB port and power button ribbon cable.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Blake Klein

Mitglied seit: 30/01/17

67752 Reputation

0 Kommentare