Einleitung
Beater Eject Button doesn't work? Follow this guide to replace it.
Werkzeuge
-
-
Insert the back of a plastic opening tool into one of the beater holes.
-
Apply force to pull the circular plastic part off.
-
If necessary, use the other side of the plastic opening tool to pry the circular plastic part off.
-
-
-
Use a plastic opening tool to remove the speed knob.
-
Use a plastic opening tool to remove the long plastic piece
-
Use a plastic opening tool to remove the speed switch.
-
-
-
Use a Phillips 2 screwdriver to remove the two 20.0mm screws holding the bottom plastic piece on.
-
Remove the bottom plastic piece using a plastic opening tool.
-
-
-
Using a Phillips 2 screwdriver, remove the three 20.0mm screws holding the motor assembly in place.
-
Use your hands to remove the motor assembly.
-
Use your hands to hold the eject button from one side while using the other hand to remove the circuit board.
-
-
-
Remove the eject button by pulling it from the inside of the mixer.
-
Hold the eject button firmly while pulling out the spring.
-
To reassemble your device, follow these instructions in reverse order.
