LG Front Load Washing Machine Drain Hose Replacement

Turn off the main water supply

Unplug your washer

Disconnect all water connections at the rear of your washer

Remove the screw(s) securing the top panel brackets to the back panel.

Slide the top panel towards the rear of the device to disconnect its clips.

Tilt the top panel upward to completely disconnect it from the chassis.

Remove the top panel.

Pull the detergent drawer away from the chassis as far as it will go.

Press down on the "Push" button to disengage the clips securing the detergent drawer.

Pull the drawer out of its slot on the chassis and remove it.

Disconnect the connectors attached to the control panel.

Remove the screw(s) securing the control panel to the top edge of the chassis.

Remove the screw(s) securing the detergent dispenser.

Use a flathead screwdriver, or a pry tool, to unclip the control panel from the chassis.

Remove the control panel, making sure to thread any cables through the chassis.

Open the front door completely.

Use needle nose pliers to grip the spring end of the metal ring at the bottom of the rubber boot.

Pull the ring away from the chassis to separate it from the boot.

Use your hand to completely pull the ring off the boot.

Insert one end of the ring into its groove along the boot's perimeter.

Use pliers to slowly stretch the ring around the boot's perimeter until it's completely nested in its groove.

Use your fingers to pull the boot off its lip on the front panel.

Slide your fingers around the lip of the boot until it's completely separated from the panel.

Open the filter panel at the bottom of the front panel.

Unclip the filter panel.

Remove the screw(s) securing the filter trim.

Pull the filter trim straight off the front panel to remove it.

Remove the screw(s) securing the lower front panel.

Remove the screw(s) securing the door latch.

Pull the door latch through its slot in the chassis and let it hang on its wire.

Remove the screw(s) securing the front panel.

Lift the front panel upward to separate it from its clips on the bottom of the chassis.

Pull the front panel away from the chassis to completely separate the front panel.

Remove the front panel.

Remove the screw(s) securing the rear panel.

Unclip the rear panel from the chassis.

Remove the rear panel.

Use slip joint pliers to pinch the drain hose clamp and slide it up the hose away from the pump assembly.

Use slip joint pliers to rotate the drain hose back and forth around its connection and loosen it.

Pull the drain hose straight off its connection on the assembly.

While holding the back of clip with one hand, use the other to push the prongs of the clip and release them.

Repeat for each prong until the clip slides through the chassis.

Reposition the drain hose so you can access the plastic clip.

Remove the screw(s) securing the drain hose.

To prevent confusion during reassembly, apply some masking tape where the plastic clip is located.

Pull the plastic clip off the drain hose.

Remove the plastic clip.

Pull the drain hose through its slot in the chassis.

Remove the drain hose.