LG K20 PLUS Ear Speaker Replacement

Geschrieben von: Patrick
  • Kommentare: 2
LG K20 PLUS Ear Speaker Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

Keine Schätzung

Einleitung

  1. KLJOV1AhF1txXgti
    KLJOV1AhF1txXgti
    QH5gUh2j4mPLTb6u

    • Remove the back cover by inserting a fingernail or opening pick here and disengaging the plastic clips.

    • Lift battery up here

  2. K61RwrCU16SIDBRo

    • Remove 11 Philips screws.

  3. qrNkclQRJT2qoMGE
    qrNkclQRJT2qoMGE
    G1uYoIkYYeK6M5Dm

    • Use fingernails or insert an opening pick into the gap between the digitizer and the midframe and pull the midframe outwards to disengage the plastic clips.

    • Carefully disengage the clips on the bottom as the headphone jack goes through the midframe.

    • Once all the clips have been disengaged, move the midframe outwards and downwards to disengage it from the headphone jack.

  4. EQpRjkOAYGLyYuap

    • Use a Halberd spudger or an opening pick to disconnect the front camera flex from its connector on the motherboard.

  5. yp1i6I3fZRxc23ro

    • Using the tip of a Halberd spudger or an opening pick, disconnect the display flex cable from its socket on the motherboard.

    • Starting from the bottom, insert an opening pick between the motherboard and frame and lever apart.

    • Be careful not to break the long section of the motherboard.

    • The top part of the motherboard is lightly adhered to the frame.

    • After the motherboard is removed, compare the original and replacement part. Some components may already be installed on the replacement display assembly.

    There is no adhesive that holds down the mother board here. There are however three plastic clips on the mid-frame that hold it down.

    I used a razor blade tool to gently pry them over to release the motherboard.

    Rick -

  6. eHEFrk2LQIZSsUCC

    • The flex cable and speaker are held in with adhesive. Use heat to soften the adhesive.

    • Carefully insert a Jimmy between the flex cable and the frame and detach the cable from the adhesive.

    • Then use the tip of a metal spudger to continue carefully prying the ear speaker up out of its housing.

    After removing the Ear Speaker it is a great time to also remove the VOLUME BUTTON FLEX. It can be seen at the top right of the photo in Step 8. It’s a little blurry, but you can see it. If you don’t transfer this item to the new unit you will be unable to control volume. This is an important step! ''

    Jeana Morales -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Patrick

Mitglied seit: 14/05/14

6439 Reputation

0 Kommentare