Einleitung
This guide will show you how to disassemble the LG Vu CU920 to replace a broken charging/headphone port. You will need to keep track of small screws, remove small components from the motherboard, and solder/unsolder a component
-
-
Remove the back cover by firmly pressing against the indent on the back panel. Slide the cover downward and off the phone.
-
-
-
Remove the battery by placing your fingernail or an opening tool at the bottom edge of the battery and lift it out.
-
-
-
Pull out the antenna to reveal a third screw.
-
Remove the 3.5mm screw with Phillips #00 screwdriver.
-
-
-
Using a plastic opening tool, gently pop out the plastic tab.
-
Use the plastic opening tool to pry up the edges of the plastic casing. You will then be able to slide it around the edge to dislodge it.
-
-
-
These six components on the motherboard must be detached before the motherboard can be removed.
-
-
-
Gently lift the ZIF connector (black tab) holding the ribbon cable in place. When it is in the upright position, remove the cable from the back side.
-
-
-
Remove the jack attached to the red and blue wires by carefully pulling it upward from the motherboard.
-
-
-
Remove the round jack connected to the black cabel by carefully prying it up from beneath with a spudger or plastic opening tool.
-
-
-
Remove the remaining three ribbon cables by gently lifting them by the ends, opposite of the cables, with a plastic opening tool or spudger until they pop out.
-
-
-
Remove the motherboard by gently prying it up with your finger from the charging port.
-
Once the board has been lifted, remove it by pulling it away from the connected edge.
-
-
-
Unsolder the charging port located on the left side of the motherboard.
-
Solder in a replacement charging port.
-
To reassemble your device, follow these instructions in reverse order.
