LeapFrog LeapPad 2 Rear Cover Replacement

Geschrieben von: Chase Mamatey
  • Kommentare: 4
LeapFrog LeapPad 2 Rear Cover Replacement

Schwierigkeitsgrad

Easy

Schritte

4

Zeitaufwand

3 - 5 Minuten

Einleitung

In order to access and replace internal components such as the cameras, motherboard, or screen assembly, you must remove the back cover of the tablet.

  1. M1YyHmJ6G2otd6lr
    M1YyHmJ6G2otd6lr
    5oRJDtPWflKHt5ui

    • Turn the tablet so the back is visible.

    • One at a time, remove the battery covers by sliding them towards the sides and away from the center of the device.

    I have changed batteries but it still don't turn on I press the power button it flashes white on screen but goes off please help

    kim30449 -

    The battery cover wont budge!

    Sunny Sky Official -

  2. LHxHfCU3oPhRSGbB

    • Remove the AA batteries from both battery compartments of the device.

    Where's the battery packs the batteries are supposed to be in ?.

    James F Crack -

    PeuTu on chAngers les piles par une batterie

    bernadette.honore -

  3. WUhh5VsMEEG2y4IU
    WUhh5VsMEEG2y4IU
    qMpmNYcp3ONUFAIS
    DA3IT2TbBDWWnsA2

    • Use a Phillips #1 screwdriver to remove the following screws from the device:

    • Four 7.0mm Phillips screws

    • Three 6.0mm Phillips screws

    • Two 10.0mm Phillips screws

    • These two screws are behind the barcode decal on the bottom of the device. Expose the screws by puncturing, cutting, or peeling the barcode decal.

  4. BX4b3Jd6fJIMuEol
    BX4b3Jd6fJIMuEol
    UvQKVrVFqPf4m6cb
    1BRXPyHUNQC4CeLD

    • Use a small plastic opening tool to begin separating the colored front cover from the white rear cover of the device.

    • With one hand on the front cover and one hand on the rear cover, start from the bottom of the device and begin pulling the pieces apart.

    • The most stubborn tabs holding the front and rear together are along the top edge of the tablet around the game cartridge slot. This will most likely be the last area that separates, and it may require a moderate amount of force.

    • Once only the top edge remains connected, simultaneously pull the rear cover backwards away from the front cover and upwards towards the top of the device. This should release the last remaining tabs holding the pieces together.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Chase Mamatey

Mitglied seit: 05/10/16

326 Reputation

0 Kommentare