Einleitung

  1. PCo1BKIOIHWpQU5n
    PCo1BKIOIHWpQU5n
    IDrTLUE4nyumbAnG
    • Power off the laptop and place it face-down on a non-scratching surface.

    • Using a Torx T5 screwdriver head, remove all ten 6 mm screws holding the back panel in place.

    The front center-right screw may be shorter (3.5mm) than the others (6.5mm), and may be captive in the back panel.

    Brad Bell -

  2. MixBWkKiRB1gACPo
    • Slide a plastic opening tool underneath the back case near the screen hinges.

    • Gently pry up on either side of the case.

    • You may hear popping sounds as you pry up the back case. This is normal. If the case does not open, try prying at a different angle/position.

    Make sure when replacing the back cover to use the Small T5 Screw under the track pad or else the longer ones will make it so the pad wont click.

    Phillip Loftus -

  3. 1tBjmNyWYDSrawpR
    1tBjmNyWYDSrawpR
    xJELgbqKEJbyYVbM
    • Disconnect the battery cable by gently pulling it straight out of the connector.

    • Be sure to pull parallel to the device to avoid bending the motherboard connector.

    • The battery connector does not lock and only requires light pressure to insert and remove.

    • Remove the battery from the laptop.

  4. OlAAA4Ud6McfbOc3
    OlAAA4Ud6McfbOc3
    JI1o2XKsdV1SkSPw
    wZRpe5fQyERM4ZXY
    • Using an opening tool, carefully flip up the retaining flaps holding the silver video cable in place.

    • Slide the ribbon cable out of each connector.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Kristen Gismondi

Mitglied seit: 12/11/14

71827 Reputation

0 Kommentare