Lenovo Ideapad 320-17IKB Fan Replacement

Geschrieben von: Kristen Gismondi
  • Kommentare: 2
Lenovo Ideapad 320-17IKB Fan Replacement

Schwierigkeitsgrad

Easy

Schritte

8

Zeitaufwand

15 - 20 Minuten

Einleitung

  1. qPd2DtrQgRKQKb1t

    • Turn off and unplug the computer.

    • Flip the laptop over so that the back panel is facing upwards.

  2. 3TCtqgvmXOsIcHPa
    3TCtqgvmXOsIcHPa
    Dn3la3RNcWOwssoE

    • Remove fourteen 7mm Phillips #00 screws from the back panel.

    Philips 0 or Philips 1 works better.

    Thorbjørn Kühl -

  3. cETjVT2ijDGZjOnR

    • Carefully remove the optical drive by pulling the bezel away from the laptop.

  4. FarGMLbgqCstKtah
    FarGMLbgqCstKtah
    O1X1ANpWQbmUOr25

    • Use your fingers or an opening tool to gently remove the back panel from the bottom of the laptop.

    • Lay both sides of the laptop next to each other.

  5. Gncn2rB4H3IAOp3J
    Gncn2rB4H3IAOp3J
    WNAVPm1UOoGw5mVw

    • Remove five 7mm Phillips #0 screws from the battery holder.

  6. ox5ekt26Dux4BYHm
    ox5ekt26Dux4BYHm
    1NfNYE2ZfrvTyJr6

    • Pinch the connecting cord with one hand and pry the battery connector with the other hand, while gently pulling the connector straight out and towards the bottom edge of the base.

    • When removing the battery, use care to keep it flat and do not open the battery because it can result in fire or explosion.

  7. ENoigThuOjCYVdRO
    ENoigThuOjCYVdRO
    YcH6McNBZHUONhRg

    • Remove five 7mm Phillips #00 screws from the cooling fan.

  8. MnkbuQESp1hwUKBq
    MnkbuQESp1hwUKBq
    xRYfaknwH2oPUCDS
    HtKgBNRJnoVsWO32

    • Gently lift the fan assembly out of the laptop.

    • Gently remove the connecting wires from the exterior of the fan by slowly "weaving" the cord between the ridges of the fan.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Kristen Gismondi

Mitglied seit: 12/11/14

71827 Reputation

Ein Kommentar

Very helpful instructions. However, Step 6 indicates that you should remove 5 screws, but really you only need the 2 on the left that are actually connecting the fan to the system board, the rest are unnecessary. In fact, the machine I replaced this on only had the one screw in the top-left.

Jeff Breuer -