Einleitung

If your Lenovo ThinkPad X1 Carbon 4th Gen (20FB002LUS) is not holding a charge or not charging at all, the battery may need to be replaced. Follow this guide to replace the main lithium-ion battery in your laptop.

The main lithium-ion battery in your laptop is responsible for powering your device when it is not plugged in. Over time, the battery may degrade and drain faster during use—this problem can be solved by replacing the battery.

This guide covers how to replace the primary battery on your laptop. If your device is not powering on at all, it’s recommended that you check the smaller coin cell battery first, since replacing the small coin cell is done more easily and costs less than the larger lithium-ion battery. A guide for replacing the coin cell battery can be found here.

Before starting this guide, make sure to power down the device fully and unplug any exterior sources of power from the laptop.

  1. EWEGftIys6buLGvr
    EWEGftIys6buLGvr
    kGOQlRdHl6esB6xb
    • Unscrew the nine captive screws on the bottom cover of the laptop using a Phillips #1 screwdriver.

    • The screws do not fully come out of the back cover, so there is no need for screw management.

    • There are a few small clips around the edge that you may need to pry at to free them. An opening pick may be helpful for this process.

  2. SWxqHmFIlAVCASY6
    • Lift the back cover up and off of the computer.

  3. NBmYc4JWFrrEorei
    NBmYc4JWFrrEorei
    QjJ4k1OJXvmiR2cQ
    GvZiyLeulcPDbWDj
    • Carefully unplug the speaker connector by pulling it towards you.

  4. EvtTvPNvvTRJ1NPq
    EvtTvPNvvTRJ1NPq
    tfXD6fm4sBVdQSbK
    • Remove the two 5 mm screws on each speaker with a Phillips #1 screwdriver.

  5. TYlgL1Jbx4tYDXlD
    TYlgL1Jbx4tYDXlD
    aOp5ybrrMBM3y1gY
    • Unweave the blue and white wires from underneath the plastic tabs connected to the battery.

  6. BSDrNH2qUATJOR5e
    • Lift each speaker up and out from the computer.

  7. J4DFjdMHXLlbK4Dv
    J4DFjdMHXLlbK4Dv
    kUGKoE2XFUq6burY
    1oHNIS5Gpfyi2mLU
    • Carefully lift the far end of the battery connector with an opening tool facing towards you.

    • Remove the connector by pushing it forward and lifting.

  8. qX3GFvnej1dMS2DR
    qX3GFvnej1dMS2DR
    xehDmPqMOA5E4MFO
    • Remove the central 5 mm screw with a Phillips #1 screwdriver.

  9. dECPUAZYMM1BhPhl
    • Lift the battery up and out of the computer.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Alexander Davis

Mitglied seit: 23/01/20

945 Reputation

Ein Kommentar

Use a Phillips #0 not a #1 or P0 driver. It makes life a lot easier. ??

Jim Barbieri -