Einleitung

If your device isn’t properly registering clicks or if the cursor isn’t properly tracking your finger movements, it may be time to replace the trackpad. Follow these instructions to replace the trackpad in the Lenovo Yoga 910-13IKB.

  1. mOQxDmSyXl4G6TMe
    mOQxDmSyXl4G6TMe
    OKPc5kPSyVUOx6XA
    • Turn the laptop over and remove the ten Torx T5 screws along the perimeter of the bottom panel using the T5 Torx Screwdriver.

    • Remove the back panel from the device exposing the components.

  2. iIp5d1lkTsrTaTFP
    • Remove the four 3 mm Phillips #0 screws holding the battery in place.

  3. BCIgxPVZHo1JFP1e
    BCIgxPVZHo1JFP1e
    XTeY1iFJAdgyoFNU
    p3vbWWq2dFXWAiNq
    • Disconnect the battery cable from its motherboard socket by gently pulling it towards the battery. The spudger tool may be needed to lift the flap seal.

    • Pull parallel to the battery, not straight up.

    • Pull evenly on the width of the cable so that no individual wire is overly strained.

    • Lift the battery out.

  4. ZQmPONsMFoPjCX5r
    ZQmPONsMFoPjCX5r
    gDctVJGiwfob5r56
    MeMdHph1IG4S21bU
    • Using the Phillips #0 screwdriver, remove all six screws holding the trackpad to the device.

    • Find the ribbon cable, the black bundle of wires attached to the trackpad, and lift the head of the ribbon cable towards you.

    • Carefully lift up the trackpad and remove it from the device.

    This step is not needed.

    You can repalce your Motherboard without this step.

    Andreas -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Isaiah M Allgeyer

Mitglied seit: 15/02/21

217 Reputation

0 Kommentare