Lenovo Yoga Tablet 10 Back Camera Replacement

Geschrieben von: Juan Benjamin
  • Kommentare: 2
Lenovo Yoga Tablet 10 Back Camera Replacement

Schwierigkeitsgrad

Moderate

Schritte

7

Zeitaufwand

15 Minuten

Einleitung

Before you proceed with this guide, you should know how to remove the back cover.

  1. nWX3CWZZ4DcdDUMW

    • Remove the two Phillips #000 screws.

    • These screws are located behind the stand for the device.

    • Our device did not include these screws.

  2. BWShHZ3TZHOoR2VJ

    • Use a plastic iFixit opening tool to pry the edges of the back case loose by placing it in between the edge of the cover and the screen.

    • Do not immediately attempt to remove the back of the case without attempting Step three, or you risk snapping the back cover.

  3. 3NcExvPo6rJS6JAW
    3NcExvPo6rJS6JAW
    SKtg3VLeuMKa2QIU

    • Use the spudger to reach into the center of the device and pry off the back case by giving it a light force upwards.

  4. MaJPE2CewyWppryT
    MaJPE2CewyWppryT
    vm6tAMuKXVlX1exH

    • Remove one 5mm screw using the Phillips #00 Screwdriver.

  5. 4Pk1gyH2esExhHeA
    4Pk1gyH2esExhHeA
    IAYIGJjLy3qaTVWb
    1KQCiAV1T55ZjYd2

    • Use the spudger to disconnect the camera and battery from the printed circuit board by putting the spudger in between the connections and the printed circuit board and pushing the spudger up.

  6. 3DmD1L6oRZQWYOGZ

    • Remove one 5mm screw with the Phillips #00 screwdriver.

  7. vPR5o26NlhKBaNsN
    vPR5o26NlhKBaNsN
    CXiKOwgCHfQWD6u5
    AG2TTX2fn3PWiRJI

    • Use the nylon tip tweezers to push the camera out from between the power button and the kickstand.

    Be careful not to break the power buton flex cable. You can desolder it from the motherboard. If necesary

    Claudiu Nistor -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Juan Benjamin

Mitglied seit: 24/01/19

490 Reputation

Ein Kommentar

“To reassemble your device, follow these instructions in reverse order. “ Including unripping the power switch tail, which is soldered to the board. Look at the last picture!

The camera/speaker assembly cannot be removed without unsoldering this tail.

Fixin Ma Stuff -