Logitech Extreme 3D Pro Disassembly of the base

Geschrieben von: Emanuel Canela
  • Kommentare: 2
Logitech Extreme 3D Pro Disassembly of the base

Schwierigkeitsgrad

Very easy

Schritte

5

Zeitaufwand

1 - 5 Minuten

Einleitung

After extended use certain parts may require cleaning or replacement. This guide will assist you in safely disassembling the base portion of the joystick. This will require to have to handle already disassembled.

  1. ifhZCZwXn2SySdkS

    • Remove these three Phillips #1 screws:

    • Two 10mm screws.

    • One 7mm screw.

  2. 66wFFnSOg3jfoFnD

    • Using your fingers, lower the rubber boot to reveal two screws underneath the joystick.

    • Remove the two 10mm Phillips #1 screws.

  3. Lqxji5uwBiv2KAyJ
    Lqxji5uwBiv2KAyJ
    HRc6nwCxcxt1XuFb

    • Pull apart the joystick chassis by hand.

    • Release this clip located underneath the hand rest

    • The circuit board will be loose and may fall down.

  4. 3TX5NMxtv1mXtc1a

    • Remove the eight 10mm Phillips #1 screws from the bottom.

    There is a 9th screw that you need to remove near the cable

    gigakoulis -

  5. IuYBpuAJkpaRhtrT
    IuYBpuAJkpaRhtrT
    6ueJblDYFbyUAEfQ
    UpvWZhpoN2N552Qh

    • Flip the joystick upright.

    • Lift up the sliver base cover and feed the loose circuit board through.

    • Careful with the wires still attached to the silver base cover from the bottom of the joystick.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Emanuel Canela

Mitglied seit: 25/01/18

1265 Reputation

Ein Kommentar

And you didn’t even finish the repair. Thanks for nothing. :(

Jesse James -