Einleitung

  1. 2UeR6BBPGlFPOAGh
    2UeR6BBPGlFPOAGh
    oDRSCeuRsoyTJCdJ
    • Remove battery cover, pushing down on circled areas and pushing outward

    • Remove battery by lifting up on corner exposed by indent in case

  2. Oan2KC4VDiVoT1Nd
    • Use a J0 screwdriver head

    • Remove 3 screws from battery compartment

  3. nWJNgdUGgR5EvYxA
    nWJNgdUGgR5EvYxA
    e3ZgtWRq1wespBgv
    • Open connector port on side

    • Remove screw with PH00 screwdriver head

  4. oiDtymU3TfG6GgmK
    oiDtymU3TfG6GgmK
    TvfKuTGrGvy6r1uk
    quDGv6cvsML5ZRnV
    • Use plastic opening tool to pry at the open slits on the side.

    • One or two silver foam cubes may pop out of the device. These belong in the slots shown in the third picture. They do not need to go back until reassembly.

    • Also the plastic connector door will fall off. It will need to be put back upon reassembly.

  5. YEx5QOJXU3tNRCpD
    • Pop out plastic screen backing on front of device.

    • Loosen screen backing by pushing back on plastic clips that are holding the black screen backing in place.

  6. aL1OgLkkcfqrcqPy
    aL1OgLkkcfqrcqPy
    mnT2y3TTVCYW1RDT
    • Use PH00 Phillips head from the iFixit Tool Kit to remove 3 screws from the circuit on the back half of the device.

    • Flip over the larger circuit board to the left.

    • Use the edge of the circuit board to flip the board over.

    • The connector port in the top right corner may make removal difficult. Lift the logic board above the screw ports, and the connector port should slide out easily.

  7. CWXRvvJPfiTuD43w
    CWXRvvJPfiTuD43w
    VjFMms5kaCnkQtCA
    • Find the wire that attaches to the screen

    • Push dark grey bar that is used to lock the screen in place, outward from beige bar to disconnect.

    • Remove screen wire

Alex Turissini

Mitglied seit: 11/02/16

19 Reputation

0 Kommentare