Einleitung

  1. sHyYoPQGPcQBNMUk
    sHyYoPQGPcQBNMUk
    n1ccbtZeQoLZFUan
    • Press the oval shaped button on the lower back of the remote to release the battery cover.

    • While pressing the button, remove the cover.

  2. xNWTFlRxIyAAvjZX
    xNWTFlRxIyAAvjZX
    S5FwrYPjoDme2s1Q
    • Push the battery in, pull it up, and slide it out.

  3. vje1FIMHwDhd6BqU
    • Using tweezers, peel off the sticker located under the battery cover to reveal two screws.

  4. KrH5WLZip1JIHiGi
    KrH5WLZip1JIHiGi
    w1d2YHvI14MWqgIx
    • Locate and unscrew the four 50mm screws using the Philips #0 screwdriver.

  5. LYgshPKMXj2VRf6b
    • Use a credit card to pry the black, plastic, back cover off of the device.

    • You may need to get the process started with a metal prying tool before you start using the credit card.

  6. Dd6rcyJGAX6qbmsl
    Dd6rcyJGAX6qbmsl
    ms1unukRoxtko4w4
    • Locate the three 50mm screws on the back of the remote and remove them using the Phillips #0 screwdriver.

  7. OfgSeFNaJOXxKXMk
    OfgSeFNaJOXxKXMk
    fRmMQFIqbkBJw6dE
    • Pry the black, front face of the remote from the back silver part by inserting a credit card in between and sliding down.

    • Again, you may need to use a metal prying tool to get the separation started.

  8. ZldwPOeheVLHocLG
    ZldwPOeheVLHocLG
    oADQ5JyYabJCANqL
    • When you look at the circuit board, you should see a ribbon attaching the board to the plastic casing.

    • A little lever is holding the ribbon in place. Lift the lever with your nail or a 2.5mm flat-head screwdriver. Move the ribbon away from the circuit board.

  9. QLyhLFuMJcnjRKrV
    QLyhLFuMJcnjRKrV
    mLkohhCxIkwqFsnm
    • Using the Philips #0 screwdriver, remove the three 50mm screws from the circuit board.

  10. VvGQ3kRPX6q6kvdG
    • Using your hands, carefully separate the motherboard from the rest of the remote.

Abschluss

To reassemble, follow the steps in reverse order.

John Adams

Mitglied seit: 25/09/17

116 Reputation

0 Kommentare