Mad Catz Street Fighter IV FightPad Circuit Board Replacement

Geschrieben von: Jefferson Hsu
  • Kommentare: 0
Mad Catz Street Fighter IV FightPad Circuit Board Replacement

Schwierigkeitsgrad

Easy

Schritte

7

Zeitaufwand

5 - 10 Minuten

Einleitung

Use this as a guide to remove the motherboard so you can access the FightPad's buttons and directional pad.

  1. pm416YSWvG5ucNwk

    • Use tweezers to completely remove the sticker from the rear of controller.

  2. 3uXvLlgQHkmtRRUM

    • Find the seven 8.3 mm Phillips screws on the rear of the controller and remove them.

  3. FumE6DnlEejBvJim
    FumE6DnlEejBvJim
    EOnKxbsxMUVWcPcp

    • Use a plastic opening tool to separate the rear and front casing by inserting it in-between the two cases.

    • Use the plastic opening tool to pry the two cases apart.

  4. VVEjO1MLOoycT6Qt
    VVEjO1MLOoycT6Qt
    IJqQCC1YUNNyCDK3

    • Remove the two rubber side grips.

  5. 6mf2FoIsZRtoAyTA
    6mf2FoIsZRtoAyTA
    unvODXCdUGvmTYGU

    • Locate RS-DP-LS switch.

    • Pull upwards on the switch to remove it.

  6. viIJjwUHe2BtVuuD

    • Locate the four 8.3 mm Phillips screws on the circuit board and remove them.

  7. hiophYM5WgcCxTmQ
    hiophYM5WgcCxTmQ
    s33OpVCF5QyrPnlp
    fJSaAKgMbFlQCEAW

    • Hold the controller cable at the area just before it meets the controller and slowly lift upwards to slide it out of its plastic slot and remove the circuit board.

    • Be careful with the wires connected to the circuit board itself as they are thin and delicate.

    • When reassembling the controller, make sure that the bottom plastic piece is fully inserted into its slot before replacing the circuit board.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Jefferson Hsu

Mitglied seit: 19/09/12

411 Reputation

0 Kommentare