Magellan RoadMate 1200 Motherboard Replacement

Geschrieben von: Ross Light
  • Kommentare: 4
Magellan RoadMate 1200 Motherboard Replacement

Schwierigkeitsgrad

Moderate

Schritte

6

Zeitaufwand

10 - 15 Minuten

Einleitung

This guide will outline how to replace a Magellan RoadMate 1200 motherboard. This piece is an integral part to the system, and may malfunction or break after a long period of use.

  1. VgTkNJfL6VlmwuA1
    VgTkNJfL6VlmwuA1
    psaePSmdZBp2Sa1e

    • Remove the four rubber caps from the back by using the Phillips #00 screwdriver.

  2. OeSvGyZAceYbcNEW

    • Remove the four screws holding the cover in place by using the Phillips #00 screwdriver.

  3. JeXyCOW2EvmVYGtc
    JeXyCOW2EvmVYGtc
    KlbuxowURVIt1XKj

    • Remove the back cover from the device by separating the back cover along its seam.

    • Slowly lift the cover—the speaker is screwed onto the back cover and is connected to the circuit board.

  4. a4AiVyY6pPepaCxd
    a4AiVyY6pPepaCxd
    JqJwhBpkT3lnNS6F

    • Pull the speaker cord, horizontally, by its base, away from the motherboard.

    • When reassembling, make sure that you plug the terminal in the same way. The black wire should be on the side farthest from the battery.

    In my 1200, the speaker is glued to the back and soldered into the board so there is no plug to undo. Just carefully find a position so that board doesn't pull on the speaker wire while it is open.

    Jomar -

    where can we get the speakers from? please

    bbunni1404 -

  5. CNsmniyHdbDfFwji

    • Remove the two screws on that are located on opposite sides of the board.

    For me, there were two screws, just located at the corners. One was near where the speaker is soldered to the board and the other was diagonally across the board where the GPS unit is soldered into the board.

    Jomar -

  6. 1EKjgPYJuS1TwBUf

    • Lift up the circuit board and disconnect the GPS wire, pulling horizontally from its connector port.

    My GPS unit, as mentioned, is soldered into the board, so no conector to remove. The GPS unit lifted right out with the board and was not attached to the display at all.

    Jomar -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Ross Light

Mitglied seit: 12/04/10

196 Reputation

0 Kommentare