Magic Bullet NutriBullet Outside Casing Replacement

Geschrieben von: Angela Wong
  • Kommentare: 4
Magic Bullet NutriBullet Outside Casing Replacement

Schwierigkeitsgrad

Moderate

Schritte

8

Zeitaufwand

15 Minuten

Einleitung

The exterior component of the NutriBullet’s powerbase consist of a silver, plastic shell casing. Use this guide to replace the cylindrical shell to ensure no leakage, exposure of wires or spinning components are showing through.

  1. cWUnfTDVVJCBJ2T4

    • Unplug the device from the wall and turn the powerbase upside down.

  2. gCbOLE2FyWrMN5pv
    gCbOLE2FyWrMN5pv
    2TDlMg6LtlU2x1CU

    • Use a #2 Phillips Head Screwdriver to unscrew the four 10 mm screws located on the bottom of the power base.

  3. ujEW2SMeZofertYq

    • Use slight tension to remove the plastic base from the NutriBullet once all of the screws are removed.

    • Once the plastic base is removed, there is a fan located in the center of the powerbase. Make sure the cord does not get caught or frayed by the fan.

  4. tjQUvDP2KWgcOJnS

    • Lift the power cord to remove it from the side slot on the curved base.

  5. g1eDnXEVBMBZLnO2
    g1eDnXEVBMBZLnO2
    TTMSygaRalAIiFCr

    • Use a #2 Phillips Head Screwdriver to remove the two 10 mm screws that secure the white bracket down.

    • The white safety bracket holds the cord down. After removing it, the cord will be loosened.

  6. nhKwCnYWWwARTrFq

    • Use a #2 Phillips Head Screwdriver to remove the three 10mm screws that keep the base in place.

  7. s64mtOVQRKGWIXCq

    • Use slight tension to remove the curved base by lifting it upward off of the outside casing.

  8. qjCHNyaEuBHLoTuU

    • Wiggle the outside casing upward until it separates from the powerbase.

    • Hold the ring at the bottom of the powerbase to receive a better grip.

    I used my Nutribullet no more than 15 times, or maybe 20, and only for making smoothies, with almond milk, chunks of fruit, and some ground flax. I never ran the motor for more than 30-40 seconds at a time (even though the one-minute limit was nowhere to be found among the instructions. It just gave out on me. I realize now that it was made to give out after a couple of dozen uses. Now it goes to landfill. I will never again buy ANYTHING at Bed Bath & Beyond. They are in business to sell overpriced schlock.

    Judy Mellow -

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Angela Wong

Mitglied seit: 22/01/15

1072 Reputation

3 Kommentare

Ok so what happens after Step 8 of pulling the Nutribullet apart? Did I miss something?? Now I have my Nutribullet in pieces on the benchtop. Now what??

Nicole Corse-Scott -

Same problem. I can't get the drive gear on the top loose which I assume will actual give me access to the wiring. I am guessing it is a pressure fit but I can't get anything under it to pry it loose. If it is a screw attachment don't want to break it. Help.

rjurgena -

So what happens next? What is one suppose to do? Stupid help, I would say

Mary Johnson -