Einleitung
Is there a tear or cut in your cord? If so, refer to this guide to replace the power cord. This guide will require some soldering experience.
Werkzeuge
-
-
Before beginning, make sure the device is unplugged.
-
With a Phillips head #2 screwdriver, begin unscrewing the four 10mm screws located on the bottom of the power base.
-
-
-
With the Phillips head #2 screwdriver, remove the two 10mm screws that secure the white bracket.
-
-
-
After removing the gray base and silver casing, the wires will now be free and you will have easy access to them.
-
Gently pull out the two plastic covers at the end of the wires.
-
-
-
Use tape or clamps to hold the wires together for an easy soldering experience.
-
Using a soldering iron, solder your new wire to the red wire.
-
Since this guide replacement requires cutting wires, if you want to reassemble this device, you must first re-solder new wires before following the steps backwards to reassemble the device.
6 Kommentare
where am I going to be the magic bullet repair
Or
there a service center here in the philippines?
Thank u.
there a service center here in the philippines
Is there a service centre in Singapore?
I just bought the gadget in Melbourne (from Harvey Norman Nunawarding) last week. We used it yesterday but after one round of spinning, gadget went dead.
What could go round and to fix it at home?
It would be better to switch these points around because if someone begins unscrewing the screws and the device is plugged in, who knows what might happen. It's better to put the warning first instead of second.
I would correct the first line to read, "With a Phillips head #2 screwdriver, begin unscrewing the four 10mm screws located on the bottom of the power base."
Jonathan Fernandez -