Einleitung
Use this guide to service the bolt holder of the Makita Jack Hammer HM1203C 2010.
Wherever there’s grease, make sure to clean it off and replace it with new grease. The recommended grease is Makita 181490-7.
Werkzeuge
Ersatzteile
-
-
Use a small pry bar or flathead screwdriver to pry the rubber front cap off of the hammer.
-
-
-
Use a pair of snap ring pliers to expand the snap ring on the front of the hammer.
-
Remove the snap ring.
-
-
-
Compress the spring and hold it down while you pull the two retainers out of their slots and remove them.
-
-
-
Use a pair of snap ring pliers to expand the snap ring securing the bolt holder.
-
Remove the snap ring.
-
-
-
Grasp the bolt holder, rubber ring 24, and the two metal sleeves below it, and lift it off of the cylinder.
-
-
-
Use an angled pick to lift the O-ring 35.5 out of its groove on the bolt holder.
-
Remove the O-ring 35.5.
-
-
-
Use a long punch, long flathead screwdriver, or a thin, long bar to push the bolt out of the bolt holder.
-
Remove the bolt.
-
To reassemble your device, follow these instructions in reverse order.