Makita Jack Hammer HM1203C 2010 Front End Service

Geschrieben von: Adam O'Camb
  • Kommentare: 0
Makita Jack Hammer HM1203C 2010 Front End Service

Schwierigkeitsgrad

Moderate

Schritte

10

Zeitaufwand

10 - 30 Minuten

Einleitung

Service the parts in the front end of the Makita Jack Hammer HM1203C 2010.

Wherever there’s grease, make sure to clean it off and replace it with new grease. The recommended grease is Makita 181490-7.

  1. rVabLGJNSEsYg5Cy

    • Unscrew the knob securing the side handle.

  2. OyTA2gNSdjR1kmPD
    OyTA2gNSdjR1kmPD
    4A4UWnQe6jEyth2Z

    • Remove the bolt securing the side handle.

    • Remove the side handle.

  3. cdQPCAWmHlpZuqwk
    cdQPCAWmHlpZuqwk
    WZytVuLQoM1IdOQu
    2HIlqhpLeAyFxAo3

    • Use a small pry bar or flathead screwdriver to pry the rubber front cap off of the hammer.

    • This can be replaced as part of a service kit.

  4. MgV3kvWneQQTL1Ua
    MgV3kvWneQQTL1Ua
    vMXLTYjODTqRU6hN

    • Use a pair of snap ring pliers to expand the snap ring on the front of the hammer.

    • Remove the snap ring.

  5. YNdUfUDuBlW3iwTE

    • Remove the washer on the front of the hammer.

  6. Xv6FAVtBrvCNwHY2

    • Lift the front cover off of the front of the hammer.

  7. UAYHeEwcanQlXHDa

    • Lift the rubber ring off of the front of the hammer.

  8. UJtMSM6sCVyYTl6s

    • Remove the inner front cover.

  9. uET4fb1PCjtlCE6N
    uET4fb1PCjtlCE6N
    Mv34bjlW5lTgb65W
    JDmRNiEcB4NoTTF2

    • Compress the spring and hold it down while you pull the two retainers out of their slots and remove them.

  10. MNKsmQJGMqsP5XDa
    MNKsmQJGMqsP5XDa
    Q2QuwMBEDUv3QVMM

    • Remove the spring guide.

    • Remove the spring.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Adam O'Camb

Mitglied seit: 11/04/15

178852 Reputation

0 Kommentare