Einleitung
Use this guide to service the piston in a Makita Jack Hammer HM1203C 2010.
Wherever there’s grease, make sure to clean it off and replace it with new grease. The recommended grease is Makita 181490-7.
Werkzeuge
Ersatzteile
-
-
Pull the handle assembly away from the hammer, but do not completely remove it yet. It's still connected to the hammer by a power cable.
-
-
-
Use a small pry bar or flathead screwdriver to pry the rubber front cap off of the hammer.
-
-
-
Use a pair of snap ring pliers to expand the snap ring on the front of the hammer.
-
Remove the snap ring.
-
-
-
Compress the spring and hold it down while you pull the two retainers out of their slots and remove them.
-
-
-
Use a pair of snap ring pliers to expand the snap ring securing the bolt holder.
-
Remove the snap ring.
-
-
-
Grasp the bolt holder, rubber ring 24, and the two metal sleeves below it, and lift it off of the cylinder.
-
-
-
Use an angled pick to lift the O-ring 35.5 out of its groove on the bolt holder.
-
Remove the O-ring 35.5.
-
-
-
Use a long punch, long flathead screwdriver, or a thin, long bar to push the bolt out of the bolt holder.
-
Remove the bolt.
-
-
-
Use a pick to pry the striker O-ring 31.5 out of its groove on the striker.
-
Remove the striker O-ring 31.5.
-
-
-
Slide the fix guides and the rubber plate out of their slots on the housing and remove them.
-
-
-
Rotate the crank shaft and the connecting rod so that the rod is vertical and the end is at the very bottom of the housing.
-
-
-
Use an arbor press and a custom punch to carefully press the crank shaft, bearing, and gear assembly out of the housing.
-
If you don't have access to a press or custom tool, use a punch and a hammer to tap the crank shaft until the whole crank shaft, bearing, and gear assembly starts to slide out.
-
-
-
Use a pick to pry the piston O-ring 31.5 out of its groove in the piston.
-
Remove the piston O-ring 31.5.
-
To reassemble your device, follow these instructions in reverse order.