MiTM Air Compressors AM1PH6508HD 2012 Belt Guard Bracket Replacement

Geschrieben von: Kyle Smith
  • Kommentare: 0
MiTM Air Compressors AM1PH6508HD 2012 Belt Guard Bracket Replacement

Schwierigkeitsgrad

Moderate

Schritte

4

Zeitaufwand

Keine Schätzung

Einleitung

Use this guide to remove or replace the belt guard bracket on a Mi-T-M Air Compressor AM1-PH65-08HD 2012.

This is a prerequisite-only guide. This guide is part of another procedure and is not meant to be used alone.

  1. wDbJ1mNLYXPZgIrB

    • Use a 7/16 inch socket to remove the nuts and accompanying bolts securing the belt guard bracket to the rear belt guard.

    • You may need to hold the bolts in place with a 7/16 inch wrench during removal.

    • Don't misplace the washers that are removed during this step.

    • During reassembly, you may need to slightly loosen the two head bolts securing the belt guard bracket in order to properly align the bracket with the mounting holes in the rear belt guard.

  2. ZUacjCT6V4CmkuZR

    • Use a 1/2 inch socket to remove the two bolts securing the belt guard bracket to the cylinder head.

    • Don't lose the loosened spacers underneath the belt guard bracket.

    • Don't misplace the washers that are removed during this step.

  3. BSXxPpWfoCAJHEvP
    BSXxPpWfoCAJHEvP
    BW13kAOoay3Kg1Fw

    • Lift the belt guard bracket straight up to remove it.

  4. vgogGC1FWApgNk41
    vgogGC1FWApgNk41
    veIPOyeVvqtIw2DD

    • Remove the four spacers from the top of the cylinder head.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Kyle Smith

Mitglied seit: 01/02/21

35834 Reputation

0 Kommentare