Milwaukee Hex Impact Driver 2656-20 Forward/Reverse switch Replacement

Geschrieben von: BRYCE DICKERSON
  • Kommentare: 0
Milwaukee Hex Impact Driver 2656-20 Forward/Reverse switch Replacement

Schwierigkeitsgrad

Moderate

Schritte

3

Zeitaufwand

15 Minuten

Einleitung

This guide will demonstrate how to replace the forward/reverse switch on the Milwaukee Hex Impact Driver 2656-20. The First Two steps will cover disassembly of the drill. The only tool required for this repair is a T-10 Torx Screwdriver. The repair is considered moderate in difficulty and will take approximately 15 minuets.

  1. DYBQTbUXsupa11Nm
    DYBQTbUXsupa11Nm
    uxNjoOPLVOmkDK5V

    • Squeeze the red buttons on the battery.

    • While squeezing the red buttons, slide the battery forward and out to remove it from the device.

  2. bXb1lSmGPD5SO4kO
    bXb1lSmGPD5SO4kO
    NVvMUxslv5yInAXk

    • Lay the impact driver on its side.

    • Remove eight 16 mm and a single 19 mm screws using the T10 Torx Screwdriver.

    • Separate the two halves by pulling up on the top half.

    • Make sure that the half with the screw heads Is facing up during this process. This will ensure that the components do not fall out.

    • Lay the top half to the side.

  3. pvJFtItHGKhUyTRe

    • Gently move the trigger assembly out of the way and remove the switch from the device.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

BRYCE DICKERSON

Mitglied seit: 05/09/19

483 Reputation

0 Kommentare