Einleitung

How to remove the blade for replacement or to service the cutting head in a Mk Diamond Wet Saw MK660 2010.

  1. 1PxeDQYqBQ233hrw
    1PxeDQYqBQ233hrw
    IRyQRqTroDdkvOdI
    MdZQD1eHaLdr53Fb
    • Before you begin, make sure to power off and unplug the device from the outlet.

    • If the clear water pump hose is connected, remove it now.

    • Loosen the plastic knob holding the saw's cutting head in place.

    • Lower the cutting head while keeping it steady.

  2. tGXO5ZwpfDMQqleL
    tGXO5ZwpfDMQqleL
    nJuiajrrOlNUASWL
    • Unscrew the knob.

    • Remove it from the cutting head.

  3. qqmPylZjmBpUSer1
    qqmPylZjmBpUSer1
    D2vbW4t5NvitZ1r2
    • Loosen the plastic knob holding the blade cover in place.

  4. GeVKq3xu1LCI4Du2
    GeVKq3xu1LCI4Du2
    DbWeQbHwT1KeG1Ie
    2PiWwbLoYillPmVG
    • Loosen the wing nut on the blade cover pivot shaft.

    • Remove the wing nut and accompanying washer.

  5. fPx4CnQEso32iGJU
    fPx4CnQEso32iGJU
    IZZQ5RAsvjexgUmO
    • Pivot the blade cover up and pull it off the shaft.

  6. w41FMjgfuCUIBRpP
    w41FMjgfuCUIBRpP
    Dh4MCJUQIXSRK3RT
    NOvXH6sJbmxgWexv
    • Insert the provided spanner wrench into one of the four tightening holes on the inner flange behind the blade.

    • Use the the provided nut wrench to loosen the hex nut while providing counterforce with the spanner wrench.

  7. 1QIYZfoE4BmFgILE
    1QIYZfoE4BmFgILE
    Q1HRZtiQlkNXhHFs
    • Remove the hex nut.

    • Remove the outer flange.

  8. PSceQ2bcDGNsB2c2
    PSceQ2bcDGNsB2c2
    BdaSZvt3XVxDU1o2
    • Remove the cutting blade.

    • The blade can be sharp, so handle with care.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Carsten Frauenheim

Mitglied seit: 10/03/20

88317 Reputation

0 Kommentare