Einleitung

This guide will take you though the process of replacing a faulty or non-functioning speaker in your Motorola Droid 2.

  1. AlFqkCThDZR5C4E5
    AlFqkCThDZR5C4E5
    kfkPSfLYokWQMXBp
    If1Ml2ioUeutMAFl
    • Slide the battery cover toward the bottom edge of the phone.

    • Remove the battery cover from the rear of the phone.

  2. hDqCVoZoonTPxyF1
    hDqCVoZoonTPxyF1
    DCLPZ6WYPOexqYHM
    • Lift the battery out of the Droid 2 from the edge closest to the bottom of the phone.

    • Remove the battery from the Droid 2.

  3. 5UUvlxTjmWWA1rXt
    5UUvlxTjmWWA1rXt
    AOKcMCyBv2BBDugV
    • Using the tip of a spudger, peel up one corner of the silver ribbon below the battery compartment.

    • Peel the ribbon off the phone.

  4. ErBeSAIZve2UFOGV
    • Insert the flat end of a spudger and pry the plastic camera cover up off the phone.

    • The thin plastic cover is attached to the phone with an adhesive. Work slowly and carefully.

  5. gismJLA4q1sKFrOn
    • Use the tip of a spudger to remove the camera bezel stuck to the rear case.

  6. T1Z1AldK2ULBxgaK
    • Remove the seven 5.5 mm T5 Torx screws securing the rear case to the inner case.

  7. g6AZRQVdlfrmeAYH
    • Insert the flat end of a spudger and pry downwards to release the plastic tab holding the rear case to the motherboard screw.

  8. yPGkCOPtGkOOVdrc
    • Gently insert a spudger between the rear case and front case at the top of the phone, near the audio jack.

    • Carefully pry the top edge of the rear case up from the rest of the phone.

  9. sfOtxX41DE1BZQYS
    sfOtxX41DE1BZQYS
    SxwbopTjmBpSFkoj
    • With the spudger still inserted between the rear case and front case, slide the spudger along the right edge of the device, moving toward the bottom, prying as you go.

    • Continue prying along the bottom edge of the device from right to left, freeing it from the front panel.

  10. COdNLuI5VNcCxDwE
    COdNLuI5VNcCxDwE
    LZTIqGd6KF22yTwC
    • Continue prying the rear case from the front case along the left side, moving from bottom to top.

    • Lift the rear case up out of the phone.

    • At this point, the button covers on the side of the phone are free and may fall out if you tip the phone upside down.

  11. C1VsUEQkm6ZBOUse
    • Carefully lift the speaker/antenna assembly up and out of the phone.

    • If you are re-assembling your phone, insert any power, camera, or volume buttons that may have fallen out at this point.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Andrew Bookholt

578335 Reputation

0 Kommentare