Motorola Droid RAZR HD Front Panel Assembly Replacement

Geschrieben von: Brendan Baronia
  • Kommentare: 0
Motorola Droid RAZR HD Front Panel Assembly Replacement

Schwierigkeitsgrad

Moderate

Schritte

5

Zeitaufwand

Keine Schätzung

Einleitung

Use this guide to replace the entire front panel assembly on your Motorola Droid RAZR HD. This includes the

  1. ZVxP1uJJSY4RuHl6

    • Power off the device before disassembly to avoid damage or harm from electrical surges.

    • Remove the two 4.5mm screws in the bottom left and right corners of the device using a T4 Torx Screwdriver.

  2. sjBQMXE5oRBiYFuW

    • Holding the device in your hand, push the screen towards the top of the phone until it disconnects from the base of the phone.

  3. CfoOPjZQVwEQPLbY

    • Use a plastic opening tool to lift the screen from the phone.

    • Do not try to completely detach the screen; cables are still connected to the device and can be damaged.

  4. wUXJOSCO4ROBrCgR
    wUXJOSCO4ROBrCgR
    gFkIVBiWKuh2XywA

    • Use tweezers to remove the yellow tape covering the lcd/digitizer cable connector.

    • Carefully lift up the black locking tab to release the lcd/digitizer cable.

    • The cable connector is located on the bottom right section of the phone.

  5. EZF4K12TAamTjfJv

    • Lift up the screen further to reveal another cable at the top of the device connecting the motherboard to the screen.

    • This connector is located on the top right section of the phone.

    • Use tweezers to lift the black bar on top of the ZIF connector.

    • Pull the ribbon cable out of the connector with tweezers.

    • Now that there are no cables connecting the screen to the motherboard, remove the screen.

Abschluss

To reassemble your device, follow these instructions in reverse order.

Tinte & Feder

Brendan Baronia

Mitglied seit: 14/04/15

678 Reputation

0 Kommentare