Motorola Droid Turbo Mittelrahmen Austausch

Geschrieben von: Geoff Wacker
  • Kommentare: 8
Motorola Droid Turbo Mittelrahmen Austausch

Schwierigkeitsgrad

Mittel

Schritte

5

Zeitaufwand

Keine Schätzung

Einleitung

Diese Anleitung zeigt dir, wie du den Mittelrahmen an deinem Motorola Droid Turbo austauschen kannst.

  1. AXEePnT6RB6V26sV

    This di not work; I had to use a blow dryer.

    Caroline Downie -

  2. tCZUL1xPGuWG2N6U
    tCZUL1xPGuWG2N6U
    IjXaZOLUXmbQ2ebl

    • Heble die Rückseite mit einem Plastiköffnungswerkzeug ab.

    • Entferne die Rückseite.

    • Die Ladespule könnte innen an der Rückseite festkleben. Trenne sie in diesem Fall von der Rückseite bevor du diese abnimmst.

    I had to go around the case, starting on the non-button side, around the top and then the other side. This, unfortunately, pulled on the rear case, pressed the power button and turned the device back on. I would suggest starting on the button side and going around.

    Ryan Helinski -

  3. k2MAinY3olQTigXK

    • Entferne die Blende um den Mittelrahmen.

    The next immediate step should be to remove the cable for the battery from the motherboard, lower left corner. That will keep you from accidentally turning the phone on while working with it.

    decker5 -

  4. ccCTRolaCRGRQo5c

    • Die Platte des Mittelrahmens ist mit vier Torx T5 Schrauben befestigt. Drehe sie heraus.

    Step 4, there are also 2 T shaped tabs on the sides locking the mid frame plate. Above them you can see an angled hole where you can insert a paper clip to push them out and up to unlock them.

    Mike Mangiaruca -

    The WiFi on the Turbo I’m working on has stopped working. The phone was reset to factory to see if this would fix it after all other try-this-first methods to fix had failed. I opened it to check there and find nothing apparently wrong.. No bent connectors or dirty pins. Any suggestions? I started to clean this section with alcohol but decided I’d better ask first. Any suggestions?

    Rongwey -

  5. iqXC3OOKukmQ3LPp

    • Nimm den Mittelrahmen heraus.

    There's two clips to the left and the right of the midframe. Use a SIM tool and insert them into the holes above the clips, and push the clips out from the inside. Once both have been pushed the midframe is released.

    rkarnes1988 -

    Many ANY thanks for that additional tip. Rather important!

    Nate Baxley -

Abschluss

Um dein Gerät wieder zusammen zu setzen folge den Schritten in umgekehrter Reihenfolge.

Tinte & Feder

Geoff Wacker

Mitglied seit: 30/09/13

88019 Reputation

Ein Kommentar

Which circuits depend of the midframe?

gabriel.mourasant -